World's Strongest Bond
™
www.jbweld.com
Technical Data/
Use and Care Sheet
Wood Restore
Repair Putty
_____________________________________________________________________________________________________________________
DIRECTIONS FOR USE
1. PREPARE SURFACE: Clean surface from dirt, grease, oil, etc. Remove paint and primer before applying.
2. MIXING: Place a golf ball size amount of wood filler, ½” thick onto a mixing board. Across the diameter of
the putty, squeeze out a line of hardener. Mix thoroughly with putty.
3. APPLICATION: With appropriate tool, apply in thin layers until gap is filled.
4. DRYING: WORK QUICKLY! Mixture sets in about 10 minutes at room temperature. Carving and shaping can
begin in 20 minutes; sand, plane or file in 30 minutes.
5. CLEAN-UP: Tools and hands can be cleaned with acetone prior to filler hardening.
Transport Information:
This product is shipped by ground or rail as a non-regulated limited quantity. 49CFR 173.165
Prop-65:
YES
GENERAL INFORMATION
The companion product to #40003 J-B Weld® Wood Restore Repair Putty is #40001 J-B Weld® Wood Restore Liquid Hardener or #40002 J-B
Weld® Premium Liquid Epoxy.
The information and recommendations contained herein are based on our research and are believed to be accurate,
but no warranty, express or implied, is made or should be inferred. Purchasers should test the products to
determine acceptable quality and suitability for their own intended use.
PRODUCT BENEFITS
• Exterior and Interior Use
• Fill Large Cracks and Voids
• Can be Sanded, Painted & Patched
• Fast Drying-Paint in 1 Hour
• Permanently Repair Damaged & Rotted Wood
TYPICAL APPLICATIONS
• Rebuilding Frames
• Securing Joints
• Anchoring Screws
• Repairing Rotted Wood
• Repairing Garage Doors
PRODUCT BRIEF
J-B Weld® Wood Restore Repair Putty is an all-purpose, professional strength wood putty, providing permanent repairs to
damaged wood. It is specially formulated for interior or exterior wood projects; small cracks to large holes. J-B Weld® Wood
Restore Repair Putty provides a hard, workable surface in 15 minutes. It will not shrink, crack, or split; can be shaped, sanded,
drilled, carved, screwed, and painted.