Customer Help Line
USA 800-336-6500 ext 513 • Canada 800-245-8777
iTOYK949
TOYK949 Mounting Kit
TOYOTA
2009-13 Corolla
VEHICLE APPLICATIONS
©2015 AMERICAN INTERNATIONAL INDUSTRIES, INC.
TECH Ver. 12/12 PRINT Ver. 2/15
WWW.AIUS.NET
2500 East Francis Street Ontario, CA 91761, U.S.A.
USA Sales (800) 336-6500
Canada Sales (888) 922-3006
For information about other American International automotive
accessories visit our website at:
http://www.aius.net
1. Starting from the sides of the Climate controls, carefully pull the Left and Right side
trims toward you and remove side trim pieces.
2. Carefully pry the Left and Right side trim pieces located next to the radio, and beside
the upper Vent forward and remove.
3. Carefully pull the Upper vent assembly toward you, disconnect the attached hazard
button harness and remove vent assembly.
4. Remove the (1) Phillips screw from the left and right side of the panel located directly
below the climate controls.
5. Carefully lift up and towards you the trim panel from around the
shifter/ashtray/auxiliary port w/security light, and lay out of the way.
6. Remove the (4) 10mm bolts securing the factory radio to the sub-dash.
7. Carefully pull the radio forward, disconnect all attached harnesses and antenna lead
and remove radio.
DASH DISASSEMBLY
2
009-13 TOYOTA COROLLA
2 3
SINGLE DIN MOUNT APPLICATIONS
1. Attach the left and right side brackets to the main bracket.
2. Insert pocket into lower section of the main bracket.
3. Attach left and right side brackets to the rear of the pocket using
screws supplied.
4. Insert DIN sleeve into upper section of Main Frame and secure by
bending tabs on the sleeve upward, outward, and downward.
KIT ASSEMBLY
1. Remove center bar from the TOYK949 mainframe. File edges smooth.
2. Remove the Shaded tab from the bottom of each left and right mounting bracket
(see fig. B illustration below).
3. Attach the left and right side brackets to the main bracket using screws provided.
4. Insert ISO spacers to the inside upper section of left & right mounting brackets
(as shown below in Fig. B).
5. Insert ISO mountable radio between Left and Right brackets and attach radio to
brackets using screws supplied with radio (when possible) or screws supplied with kit.
6. Slide radio forward or backward for desired look and tighten screws.
7. Suggested...Support the rear of the radio component(s) with back strap.
DOUBLE DIN MOUNT INSTALLATION INSTRUCTION
Fig. A
Fig. A
Fig. B
REMOVE ALL SHADED
AREAS ON BOTH LEFT AND
RIGHT BRACKETS (LEFT
SIDE NOT SHOWN)
SINGLE ISO MOUNT APPLICATIONS
1. Insert ISO spacers to the inside upper section of left & right mounting brackets
(as shown below in Fig. A)
2. Attach the left and right side brackets to the main bracket.
3. Insert pocket into lower section of the main bracket.
4. Attach left and right side brackets to the rear of the pocket using screws supplied.
5. Mount after-market radio to side brackets using hardware included, or screws
supplied with radio when possible.
-
1
-
2
