TOYK979 Mounting Kit
Toyota
2002-06 CAMRY (Non-Navigation Vehicles Only)
VEHICLE APPLICATIONS
CUSTOMER HELP LINE
USA 800-323-4329 • Canada 800-245-8777
iTOYK979
1. Remove the Shaded tab from the top of each left and right mounting bracket
(see Fig. E below).
2. Attach the left and right side brackets to the main bracket.
3. Insert ISO mountable radio between ISO mount brackets and loosely attach to
sides of radio using screws provided with radio when possible or screws
supplied with kit.
4. Slide radio forward or backward for desired look and tighten screws.
5. Suggested..Support the rear of the radio with back strap.
DOUBLE DIN MOUNT INSTALLATION INSTRUCTION
Fig. E
Remove tabs on left
and right brackets
Attach (1) ISO Spacer to the inside of the
lower section on both Left & Right
mounting brackets asshown (Fig. D).
Left
Right
NOTE: ISO trim ring (DIT979) must be used in place of after-market radio’s trim rings. For ISO mount
applications, mount after-market radio components to side brackets using hardware included.
Fig. D
©2015 AMERICAN INTERNATIONAL INDUSTRIES, INC.
TECH Ver. 11/14 PRINT Ver. 03/15
WWW.AIUS.NET
2500 East Francis Street Ontario, CA 91761, U.S.A.
USA Sales (800) 336-6500
Canada Sales (888) 922-3006
1. Carefully unclip the climate control panel below the radio.
2. Disconnect all harnesses from the rear of the climate controls
and remove the control panel.
3. Carefully remove the trim bezel from around the radio.
4. Disconnect all harnesses from the radio trim bezel and remove bezel.
5. Remove the (4) 10 mm bolts securing the factory radio to the sub-dash.
6. Carefully pull the factory radio forward, disconnect all harnesses and antenna lead
from radio and remove radio.
DASH DISASSEMBLY
ISO MOUNT APPLICATIONS
1. Insert pocket into upper section of the main bracket.
2. Attach the left and right side brackets to the main bracket.
3. Attach left and right side brackets to the rear of the pocket using screws supplied.
4. Insert ISO mountable radio between ISO mount brackets and loosely attach to sides
of radio using screws provided with radio when possible or screws supplied with kit.
5. Slide radio forward or backward for desired look and tighten screws.
6. Suggested..Support the rear of the radio with back strap.
KIT ASSEMBLY
PO
CKET
MUST
BE
ON TOP
NOTE: Optional ISO trim ring (IT979 included) may be used in place of after-market
radioʼs trim ring. For ISO mount applications, mount after-market radio
to side brackets using hardware included.
IT979
(Bottom)
Attach (1) ISO Spacer to the inside of
lower section on both Left & Right
mounting brackets as shown in Fig. B.
Left
Right
Fig. B
2 3
SINGLE DIN MOUNT APPLICATIONS
1. Insert pocket into upper section of the main bracket.
2. Attach the left and right side brackets to the main bracket.
3. Attach left and right side brackets to the rear of the pocket using screws supplied.
4. Insert the radioʼs metal DIN sleeve into lower section of Main Frame and secure by
bending tabs on the sleeve upward, outward, and downward.
KIT ASSEMBLY
POCKET MUST
BE ON
TOP
DIN SLEEVE
Left
Right
Fig. A
Fig. C
-
1
-
2
