purpose
1
2
technical: shift lock
3
technical: zoom lock / focus lock
Quick Start Guide
OptiLoc
TM
Take care not to overtighten the screws on the OptiLoc
Fig. 3 - One ring OptiLoc
(Wide lens (EN17) - 503-0106-00) Only focus
Fig. 2 - Two ring OptiLoc
(Zoom lens (315) - 503-0102-00)
Fig. 1 - Shift & Lock
(1.5mm Allen key)
z-screw
OptiLoc
TM
is a mechanical solution to lock lens shift, focus and zoom (depending on lens type) on F22-products.
A customer friendly solution enabeling the customer to implement all the locking required for a speciļ¬c installation.
Ensures perfect positioned optics when units are installed for example in a typical motion based installation.
The images will always be in the same position and focused.
Locks the lens shift in any given position by tightening the z-screw (Fig. 1).
Shift the lens using the normal lens shift adjustment wheel, until optimal positioning is accheived. Then tighten the
z-screw (Fig. 1) using an 1.5mm Allen key to secure that it remains in this position. Make sure not to overtighten.
Locks the zoom* and focus (Fig. 2) on the lens in any given position (Fig. 3 focus only lens/One ring OptiLoc).
Set the lens focus and zoom (where available) to optimal position and then tighten the locking screws using a torx
no. 8. It is recommended tightening the zoom ring before adjusting the focus (Fig. 2/Two ring OptiLoc only).
* The zoom lock is only available on zoom lenses (Fig. 2)
601-0325-00
www.barco.com
If you encounter problems, please redo the process or contact us for assistance on our web page
601-0325-00 Optiloc Barco Quick Start Guide.indd 1 17.01.2014 10:30:12
/
