IYAR3I2693A2-C
3A02-600
R
Copyright © 2017KingSlide.AllRightsReserved
Ⓐ
innerrail
➌
outer rail / bracket
➊
Pull
➋
Click!
Ⓑ7.1 Round Hole
9.5 Square Hole
(Pre-installed)
Click!
➊➋
➌
➍
M4x4
➊➋
Click!
Pull
➊➋
Click!
➋
➊
➊
➊
➌
pull/push
➌
➌
➍
➍
➎
➎
locking
M5X13L➎
locking
➊
➊
➊
➋
➋
➋
Pull
DetachFrontBracketfromRackPost
➊
➍
➊
➋
➋
Release the latch to
detach the inner rail.
1) Remove theinner rail.
Pull tab forward
and take out
innerrail.
Note: Please check rack post type. The rail
pre-installed type is for square hole post. If
rack post is round hole post, please switch to
the suitable screws.
Remove A type screws(pre-installed)
and switch to B type screws.
2) Install the inner rail onto chassis.
3) Fix the outer rail/bracket assembly to the frame. DetachFrontBracketfromRackPost
Note:
Front and rear bracket installation are the same.
L,R side of rail are symmetrical.
Please repeat installation step for the
other side.
4) Insert chassis to complete the installation.
➊.Ensure ball bearing retainer is located at the front of the rail.
➋.Insert the chassis into outer rails.
➌.When hit a stop , please pull / push the release tab on the inner rails.
➍.➎.Tighten chassis with shipping screws.
DetachFrontBracketfromRackPost
➊.Loosen shipping screw to pull out chassis.
➋.Press the disconnect tab forward to remove chassis.
