Gigabyte R262-ZA2 Owner's manual

Brand: Gigabyte

Model: R262-ZA2

Type: Owner's manual

IYAR3I2693A2-C

3A02-600

Ⓐ

innerrail

➌

outer rail / bracket

➊

Pull

➋

Click!

Ⓑ7.1 Round Hole

9.5 Square Hole

(Pre-installed)

Click!

➊➋

➌

➍

M4x4

➊➋

Click!

Pull

➊➋

Click!

➋

➊

➌

pull/push

➌

➍

➎

locking

M5X13L➎

locking

➊

➋

Pull

DetachFrontBracketfromRackPost

➊

➍

➊

➋

Release the latch to

detach the inner rail.

1) Remove theinner rail.

Pull tab forward

and take out

innerrail.

Note: Please check rack post type. The rail

pre-installed type is for square hole post. If

rack post is round hole post, please switch to

the suitable screws.

Remove A type screws(pre-installed)

and switch to B type screws.

2) Install the inner rail onto chassis.

3) Fix the outer rail/bracket assembly to the frame. DetachFrontBracketfromRackPost

Note:

Front and rear bracket installation are the same.

L,R side of rail are symmetrical.

Please repeat installation step for the

other side.

4) Insert chassis to complete the installation.

➊.Ensure ball bearing retainer is located at the front of the rail.

➋.Insert the chassis into outer rails.

➌.When hit a stop , please pull / push the release tab on the inner rails.

➍.➎.Tighten chassis with shipping screws.

DetachFrontBracketfromRackPost

➊.Loosen shipping screw to pull out chassis.

➋.Press the disconnect tab forward to remove chassis.

Gigabyte R262-ZA2 Owner's manual

Gigabyte R262-ZA2 Owner's manual

Gigabyte R262-ZA2 Owner's manual

Related papers

Other documents