2. Chatsworth Products
  3. Radius Drop
Radius Drop

Chatsworth Products Radius Drop Installation guide

  • Hello! I am an AI chatbot trained to assist you with the Chatsworth Products Radius Drop Installation guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
N-SERIES TERAFRAME RADIUS DROP
IIS-739327, 01/09/14, Rev. 1, CPI/JAG
800-834-4969 (USA & Canada) • www.chatsworth.com • t[email protected]
For international phone numbers, see our website or contact CPI Tech Support.
This drawing contains proprietary and confidential information and is protected by U.S. and international law. Unauthorized reproduction, disclosure or use of the drawing
or the information therein is expressly forbidden except as agreed to in writing by Chatsworth Products, Inc.
Page 1 of 2
Installation Instructions
Included Hardware:
M6 X 10mm Hex Screw 4 ea.
M6 Drop-In -Nut 4 ea.
Tools Required:
10mm Wrench
Installation Notes:
1. There are two methods of mounting the radius drop.
a. Mounted on side slot of equipment slide (standard configuration).
b. Mounted on top slot of equipment slide (optional configuration).
Assembly Sequence:
The Radius Drop attaches to the top of the cabinet slides (Fig. 1).
1. Insert M6 Drop-in-Nuts into slides (Fig. 2).
Fig. 2
M6 Drop-in-nut Installation
M6 Drop-
In-Nut
M6 Drop-
In-Nut
Installed
Frame
Radius drop
Inner slide
(Always on top
slot)
Outer slide
Radius drop
Fig. 1
M6 drop-In -Nut
M6 X 10mm
Screw
N-SERIES TERAFRAME RADIUS DROP
Page 2 of 2
Installation Instructions
Standard configuration:
1. Position Radius Drop on a top slide of the cabinet (Fig. 3 & 5).
2. Fasten it by using M6 X 10mm screws with drop-in-nut at side slot (Fig.
3 & 5).
3. Maintain the gap between mesh tray and Radius Drop to be 2.2in (56
mm) (Fig. 3) to avoid interference.
Optional Configuration:
1. Position the Radius Drop on a top slide of the cabinet (Fig. 4 & 5).
2. Fasten it by using M6 X 10mm screws with M6 drop-in-nut at top slot
(Fig. 4 & 5).
3. Maintain the gap between mesh tray and Radius Drop to be 0.8in
(20.5mm) (Fig. 4) to avoid interference.
Mesh tray
Outer slide
Radius drop
0.8 in
Fig. 4
0.5 in
Mounted always
on side slot
Mesh tray
Radius drop
Inner slide
2.2 in
Fig. 3
Fig. 5
Mesh tray
Outer slide
Inner slide
Radius drop
Optional
configuration
Standard
configuration
/