Metra 95-7425 Datasheet

Category
Mounting kits
Type
Datasheet

The Metra 95-7425 is a car stereo installation kit designed for the Nissan Rogue from 2008 to 2011. It allows you to replace your factory radio with a new aftermarket double DIN or stacked ISO mount unit. The kit includes a double DIN radio housing, double DIN brackets, and all the necessary hardware for installation. The kit's modular design makes it easy to customize your installation to fit your specific needs. For example, you can choose to install a single double DIN unit or a combination of two smaller ISO mount units.

The Metra 95-7425 is a car stereo installation kit designed for the Nissan Rogue from 2008 to 2011. It allows you to replace your factory radio with a new aftermarket double DIN or stacked ISO mount unit. The kit includes a double DIN radio housing, double DIN brackets, and all the necessary hardware for installation. The kit's modular design makes it easy to customize your installation to fit your specific needs. For example, you can choose to install a single double DIN unit or a combination of two smaller ISO mount units.

INSTALLATION INSTRUCTIONS FOR PART 95-7425
95-7425
APPLICATIONS
Nissan Rogue 2008-11
KIT FEATURES
• Double DIN Radio Provision
• Stacked ISO Mount Units Provision
A) Double DIN Radio Housing B) Double DIN Brackets
Harness & Antenna Connections (sold separately)
70-7552 - Nissan Harness 07-up
40-NI12 - Nissan Antenna Adapter 07-up
KIT COMPONENTS
A
TOOLS REQUIRED:
Small Flat Blade Screwdriver/ Panel Removal Tool
Phillips Screwdriver
1-800-221-0932
© COPYRIGHT 2008-10 METRA ELECTRONICS CORPORATION
www.metraonline.com
B
Dash Disassembly
-
Nissan Rogue 2008-11 . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
1,2
Kit Assembly
- Double DIN/ Stacked ISO Mount Units Provision . . . . . . . . . . . . . . . . . 3
Final Assembly
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4
TABLE OF CONTENTS
95-7425
*Note:
Refer also to the instructions included with the aftermarket radio.
95-7425 DASH DISASSEMBLY
NISSAN Rogue 2008-11
A
B
C
1
Disconnect the negative battery ter-
minal to prevent an accidental short
circuit.
1
If equipped with center speaker:
Unclip and remove the grille
(Figure A).
Remove (4) Phillips screws
securing the speaker. Unplug and
remove the speaker.
(Figure B).
Unclip the panel above the radio
including the a/c vents, then unplug
hazard switch and remove.
(Figure C)
2
Continued on page 2.
Note:
If not equipped with center
speaker skip step number 2.
2
95-7425 DASH DISASSEMBLY
NISSAN Rogue 2008-11
A/C
PASS
AIR BAG
D
E
Unclip the panel below the radio
including the climate controls. Unplug
climate controls and remove the
panel.
(Figure D)
3
Remove (4) Phillips screws securing
the radio, unplug and remove radio.
(Figure E)
4
Continue to kit assembly.
3
95-7425 KIT ASSEMBLY
DOUBLE DIN/STACKED ISO MOUNT UNITS PROVISION
Snap the Double DIN brackets to the
inside edge of the Double DIN radio
housing.
(Figure A)
1
Slide the Double DIN or the stacked
ISO mount unit(s) into the
bracket/radio housing assembly and
secure the unit(s) to the assembly
using the screws supplied with the
unit(s).
(Figure B)
2
Continue to final assembly.
*Note: Refer also to the instructions included with the aftermarket radio.
A
B
4
95-7425 FINAL ASSEMBLY
FINAL ASSEMBLY
(A) Strip wire ends back 1/2"
B) Twist ends together
C) Solder
D) Tape
A
B
C
D
Locate the factory wiring harness in the dash. Metra recommends using the
proper mating adapter and making connections as shown. (Isolate and individ-
ually tape off the ends of any unused wires to prevent electrical short circuit.)
Re-connect the negative battery terminal and test the unit for proper operation.
Reassemble in reverse order of disassembly.
1
2
3
FINAL WIRING CONNECTIONS
Make wiring connections using the EIA color code chart shown below and the instructions included with the
head unit. Metra recommends making connections as shown below; Strip, Splice, Solder, Tape. Isolate and
individually tape off ends of any unused wires to prevent electrical short circuit.
METRA / EIA WIRING CODE
12V Ignition / Acc. . . . . . . . . . Red
12V Batt / Memory. . . . . . . . . Yellow
Ground. . . . . . . . . . . . . . . . . . Black*
Power Antenna. . . . . . . . . . . . Blue
Amp Turn-On . . . . . . . . . . . . . Blue / White
Amp Ground. . . . . . . . . . . . . . Black / White
Illumination . . . . . . . . . . . . . . Orange
Dimmer . . . . . . . . . . . . . . . . . Orange / White
Right Front (+) . . . . . . . . . . . . Gray
Right Front (-). . . . . . . . . . . . . Gray/ Black
Left Front (+) . . . . . . . . . . . . . White
Left Front (-). . . . . . . . . . . . . . White / Black
Right Rear (+) . . . . . . . . . . . . Violet
Right Rear (-) . . . . . . . . . . . . . Violet / Black
Left Rear (+) . . . . . . . . . . . . . Green
Left Rear (-) . . . . . . . . . . . . . . Green / Black
*NOTE: When a Black wire is not present, ground radio to vehicle chassis.
All colors may not be present on all leads due to manufacturer’s specifications.
95-7425
NOTES
5
95-7425 INSTRUCTIONS
1-800-221-0932
REV. 11/18/10 © COPYRIGHT 2010 METRA ELECTRONICS CORPORATION INST95-7425
www.metraonline.com
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8

Metra 95-7425 Datasheet

Category
Mounting kits
Type
Datasheet

The Metra 95-7425 is a car stereo installation kit designed for the Nissan Rogue from 2008 to 2011. It allows you to replace your factory radio with a new aftermarket double DIN or stacked ISO mount unit. The kit includes a double DIN radio housing, double DIN brackets, and all the necessary hardware for installation. The kit's modular design makes it easy to customize your installation to fit your specific needs. For example, you can choose to install a single double DIN unit or a combination of two smaller ISO mount units.

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI