2. Cabletron Systems
  3. MMAC-Plus 9F116-01

Cabletron Systems MMAC-Plus 9F116-01 Reference guide

  • Hello! I am an AI chatbot trained to assist you with the Cabletron Systems MMAC-Plus 9F116-01 Reference guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
MMAC-Plus
™
Module Local Management
9F116-01
Module Specific Appendix
9031371
1
Appendix
9F116-01 Module Specific
Information
Introduction
This appendix contains local management information that is specific to the 9F116-01
Dual Port FDDI Bridge/Router Module.
Default Interface Codes
The Default Interface field on the General Configuration Screen allows you to enter a
number (one through four). Each number represents a default interface for the
module. The table below lists the numbers you can enter, each number’s
corresponding interface, and a brief description of that interface.
The default for this field is NONE, meaning no default interface selected.
Table 1. 9F116-01 Bridge/Router Module Default Interface Codes
Number
Interface Description
1 SMB-1 1 mbps System Management Bus
2 SMB-10 10 mbps System Management Bus
3 FNB-1 Flexible Network Bus 1
4 FNB-2 Flexible Network Bus 2
9F116-01 Module Specific Information
2
FNB Resource Configuration Codes
The 9F116-01 Dual Port FDDI Bridge/Router Module provides connectivity between
three interfaces: the two front panel interfaces and one of the FDDI rings on the
backplane (FNB-1 or FNB-2).
The FNB Resource Configuration Screen allows you to connect the module’s front
panel interfaces to one of the chassis’ two FDDI networks (FNB-1 or FNB-2) via a
bridge/router.
The FNB Resource Configuration Screen lists all the possible connections that the
module can support on the FNB, displays the current connection, and allows you to
change the connection. Table 2 lists and describes the FDDI Connections from which
you can select.
3
Appendix
Table 2. 9F116-01 MicroLAN Module FNB Resource Configuration Codes
Configuration
ID
FDDI Connections Description
1 No FDDI Connections The FNB-1 and the FNB-2 on the
chassis’ backplane are not
connected to the module’s
bridge/router.
2 FNB-1 The FNB-1 on the backplane is
connected to the module’s
bridge/router.
3 FNB-2 The FNB-2 on the backplane is
connected to the module’s
bridge/router.
4 FNB-2, FNB-1 The FNB-2 and the FNB-1 on the
backplane are connected to the
module’s bridge/router.
5 Front Panel The module’s front panel FDDI is
connected to the module’s
bridge/router.
6 FNB-1, Front Panel The FNB-1 on the backplane and
the module’s front panel FDDI
are connected to the module’s
bridge/router.
7 FNB-2, Front Panel The FNB-2 on the backplane and
the module’s front panel FDDI
are connected to the module’s
bridge/router.
/