Document number: 86003-3 (use with handbook: 81057)
Date: June 2001
SportPilot & SportPilot+ Quick Reference Guide
Enter compass calibration (from Standby)
1
Turn boat in slow circles
2
SportPilot indicates amount of deviation detected
3
Align the SportPilot compass to North
4
Save changes
5
To align heading (without linearizing)
+
x1 = 5˚ deviation
10 sec
a. Press in control stalk end for 10 sec. b. AUTO and NAV lights flash alternately
5 sec
Note: To quit compass calibration
without saving, turn control stalk
to LO then back to STANDBY.
Press in control stalk to:
• save deviation correction
• save heading alignment
• return to STANDBY mode
To align the SportPilot compass without linearizing:
1. Press in and hold control stalk end for 10 sec.
2. Steer boat onto magnetic North heading.
a. Steer the boat on a magnetic North heading. b. Press either -1 or +1 to align SportPilot compass to North.
• after the 5 sec beep, the SportPilot beeps to indicate amount of deviation detected
• each beep = 5˚ deviation (1 beep = 0˚-5˚; 2 beeps = 5˚-10˚; 3 beeps = 10˚-15˚)
• 4 or more beeps = deviation above 15˚: re-site compass then repeat linearization
Turn the boat in slow circles:
• speed less than 3 knots
• at least 2 mins for each 360˚
Keep turning the boat until:
• the AUTO and NAV lights flash together
• the SportPilot beeps for 5 sec
Compass calibration
Note: compass calibration is only necessary if you have been unable to mount the compass so it faces the bow.
Start turning boat
(see step 2)
D5598-1
3. Press either -1 or +1 to align SportPilot compass to North.
4. Press in control stalk end to save heading alignment.
86003_3.book Page 2 Monday, July 9, 2001 12:00 PM