GOCLEVER CITY BOARD S6 BLUE LG Quick start guide

PL Oryginalna instrukcja obsługi

EN Translation of original user’s manual

DE Übersetzungen der Originalanweisungen

IT Traduzione delle istruzioni d’uso originali

CZ Překlad originálního provozního návodu

Models: CBLS6BEU, CBLS6WEU, CBLSX6BEU, CBLSX6WEU, CBLSX8BEU,

CBLSX8WEU, CBLS10BEU, CBLS10WEU, CBLSCRREU, CBLSSBEU

Rev. 1.5

Page is loading ...

EN

12

1. Introduction

Thank you for purchasing our product. We believe you will enjoy it enormously and

will have lots of fun using it. The board will improve your motor coordination and will

develop your balancing skills. Before you start riding the board, please read through

this Manual and save it for future reference. The board is intended for private,

recreational use only.

2. Construction

A Footplate.

B Condition indicators.

C Wheel guards.

D Wheel with a built-in motor.

E Tire.

F Charging plug.

G Power button.

Contents of the package: Operating Manual, battery charger, transport bag.

3. Technical specification

Maximal speed

Up to 15 km/h

Temperature of operation

-10°C to +40°C

Battery

Li-ion 36 V, 4.4 Ah (LG)

Minimal load

20 kg

Maximal load

120 kg

Net weight

10 kg CBLS6(xxx) , CBLSX6(xxx)

12 kg CBLSX8(xxx), CBLS10(xxx)

13.9 kg CBLSS(xxx)

Nominal power

0.7 kW

EN

13

4. Principles of safety

To ensure safe use of the board you must comply with instructions contained in this

Manual.

Note! The rider must wear helmet, knee, elbow and wrists pads.

Note! The board does not meet the general road traffic regulations and cannot be

used on roads and sidewalks. Please always pay attention to other people when

using the board. Keep far away from bystanders when riding the board.

The recommended age of the board user is over 14. The product is intended for one

user only, of a maximal weight below 120kg.

The board should be used on a flat surface. Avoid steep and ice-covered surfaces,

bumps and steps. There is a risk of slipping and falling on smooth surfaces.

Note! The board is not indented for jumping!

Note! Never use the board in poor visibility or in darkness!

Do not modify the product as a modification may endanger your safety. The board

does not contain any parts which are serviceable by the user. Do not repair the

product on your own. Always have the board repaired by a specialist.

Protect the board from water and other liquids. Neither the board not the battery

charger is waterproof. Please do not use them near water and on other areas where

excessive amounts of water are present.

Note! Motors in the wheels may overheat when the board is in use for a long time.

Do not touch the motors until they cool down – a risk of burn!

Noise emission: the equivalent continuous A-weighted pressure level at workstations

not exceeds 70 dB (A).

Vibration: Measured value of whole body vibration does not exceed 0,5 m/s

2

.

5. Use

Step 1. Switch on the board pushing the power button (G).

Step 2. Correctly position your feet on the footplate (H.1). First, put one foot on the

board. The sensor will activate and the indicator will change into green. Put the other

foot of the footplate to start riding.

EN

14

Step 3. Control the movement of the board by balancing your body, keeping the

center of gravity to maintain balance. By gently balancing your body forwards and

backwards you will keep the board moving (H.2). Please remember not to make any

rapid body movements.

Tip: When riding the board, slightly relax your legs and bend them at the knees to

maintain balance.

Step 4. Turning right and left on the skateboard (H.3). Transfer your weight to the

front part of your left foot to turn right. Transfer your weight to the front part of your

right foot to turn left.

Step 5. Climbing off the board. Keep the board well balanced before climbing off. Put

one foot on the ground and quickly take the other one from the board.

Note: When the board is turned on and is not accurately positioned ensuring

stability and balance, the beeper will sound and the alarm indicator will come on.

In such case the balance cannot be automatically adjusted.

Additional instructions concerning safe use

At first, practice riding in the open space, so that you are able to easily climb onto the

board, ride forward and backward, turn, stop and climb off the board. Put on

comfortable, sport clothes which will give you freedom of movement in emergency

situations.

When you are riding fast and when you are changing the position of the center of

gravity, please remember to balance your body to avoid falling down from the board.

Adjust the speed, you are riding with, to other conditions to ensure safety for

yourself and other persons present in the vicinity. If you are riding in a group of

riders, please remember to maintain appropriate distance between each other to

avoid collision.

Remember you are 10 cm higher standing on the board. Bow your head riding

through a door or under obstacles to avoid risk.

Protective functions

All faults and system errors occurring during use are signalized with a beep sound

and a light indicator. You must then immediately stop riding!

EN

15

The most frequent causes triggering the alarm include: footplate tilted by more than

15 degrees, too low battery voltage, motor overload, excessive speed, low battery

charge, the board being swung forward and backward for more than 30 seconds. The

board will turn off within 2 seconds, also when its wheel is blocked.

Charging the battery

If the battery charge level is lower than the safe value, the board will signal it with a

red light on the battery indicator (B) and a beep, after 15 second the board will

automatically turn off.

If the battery goes down to the minimal charge level, further ride will have a negative

effect on the battery life, increasing the risk of falling down.

Make sure that the board is turned off.

Plug in the battery charger into the power plug (F) in the board.

Plug in the battery charger to the mains socket.

The battery needs about two hours to charge. The end of the charging process

is signaled with an indicator (B).

Please remember to only use charger which is attached to the set. Before and during

charging, the temperature of the board should remain in the range from 10°C to

40°C. It will ensure the best efficiency of the charging process and the battery life.

Device Calibration

If the vehicle seems to "pull" to the left or right, it may be necessary to recalibrate

the sensors. This process requires an additional device like spirit level (preferably

two). Many smartphones have free application "spirit level". Then follow these steps:

 Place the board on a flat level surface.

 Ensure that the board is off.

 Use a level to adjust the level of each wheel. It is important that the two pulleys

are levelled evenly and at the same time.

 After confirming that both wheels are properly levelled, press and hold for about

5 seconds the power button (G) until the blue lights start flashing and you will

hear a beep.

 When the LEDs stop blinking calibration is complete.

 Turn off the board, turn it back on, and you can use the equipment.

EN

16

6. Cleaning, storage and transport

Adequate and regular cleaning guarantees safe use and extends the usable life of the

board. All the elements of the board are cleaned using a dry cloth. Note! Do not use

any strong chemicals, caustic, abrasive or disinfecting chemicals for cleaning, because

they may have negative effects on the board surface.

Note! Do not immerse the board or the battery charger in water or liquids.

Always store the board in a dry, ventilated place, inaccessible to children. Protect the

board against vibrations and shock during transport.

If you are storing your board long-term it is recommended to charge the battery to

about 30% - 50%. Regularly check and recharge the battery if needed.

7. Explanations

Read the Operating Manual.

Product complies with the requirements of the European

Community directives.

Disposal of electric and electronic devices.

This sign means that upon the end of its usable life, the device

should not be disposed of together with other waste. To prevent the

possible negative impact on the natural environment and the health

of people, waste should be properly segregated and responsibly

recycled, promoting further use of the material resources. Please

dispose of the board using the functioning waste collection systems

or contact the shop the device was purchased from.

Note! The design of the product and its technical parameters can be changed

without further notice. The manufacturer does not take any responsibility by way of

damages for any inconsistencies resulting from errors in this User Operating Manual.

EN

17

EU Declaration of Conformity (translation)

no 085/16

Manufacturer: GOCLEVER SP. Z O. O.

ul. SKÓRZEWSKA 35, WYSOGOTOWO

62-081 PRZEZMIEROWO, POLAND

We hereby declare that this product:

Brand: GOCLEVER

Product name: CITY BOARD -PLUS -S6 -SX6 -SX8 -S10 -SUV

-CRUISER

Model: CCBLS6(xxx), CBLSX6(xxx), CBLSX8(xxx),

CBLS10(xxx), CBLSC(xxx), CBLSS(xxx).

Function: Device for transport of one person

complies with the requirements of the harmonised EU Directives: 2006/42/EC,

2006/95/EC, 2004/108/EC, 2011/65/EU.

This device has been designed and manufactured in compliance with the following

standards:

EN 60204-1:2006 +A1:2009 +AC:2010, EN 60335-1:2012 +A11:2014,

EN 62233:2008, EN 55014-1:2006 +A1:2009 +A2:2011, EN 55014-2:1997 +A1:2001

+A2:2008, EN 61000-3-2:2014, EN 61000-3-3:2013, BS 1363-1:1995 +A4:2012, EN

62133:2013, IEC 61558-1:2005 +A1:2009, IEC 61558-2-16:2009, EN 55024:2010, EN

55022:2010

Duly authorised person: ROMAN PANEK (GOCLEVER SP. Z O. O., ul. SKÓRZEWSKA 35,

WYSOGOTOWO, 62-081 PRZEZMIEROWO, POLSKA)

Place and date: Przeźmierowo, 19.10.2016

President of Board

Roman Panek

Page is loading ...

GOCLEVER CITY BOARD S6 BLUE LG Quick start guide

GOCLEVER CITY BOARD S6 BLUE LG Quick start guide

in other languages

Related papers

Other documents