2. Razor
  3. W15128040012
W15128040012

Razor W15128040012 User manual

  • Hello! I've reviewed the Razor Chain replacement instructions for the RSF350 model. This document outlines the steps needed to change the chain, including which tools are required and how to ensure a safe procedure. I'm ready to answer any questions you might have based on the information provided.
  • What tools are needed for chain replacement?
    What should I do before starting chain replacement?
    What is the first step in the chain replacement process?
    How to install the new chain?
Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Pacific Time.
1
WARNING
Step 1 Step 2
Required Tools: (Not included)
A. Phillips screwdriver
B. 14 mm wrench
C. 17 mm wrench
CAUTION: To avoid potential shock or other injury, turn power switch OFF and disconnect
charger before conducting any assembly or maintenance procedures. Failure to follow these
steps in the correct order may cause irreparable damage.
Using a Phillips screwdriver, loosen the four (4) screws
and remove chain guard.
Using a 14 mm and 17 mm wrench, loosen the locknut
and axle bolt on the rear wheel.
RSF350 CHAIN
REPLACEMENT INSTRUCTIONS
PART # W15128040012
Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Pacific Time.
2
Step 3
Step 5
Step 4
Push the chain tensioner down to loosen the chain and
remove the chain from the wheel sprocket and motor
sprocket. Push wheel downward to remove.
Re-attach the chain guard.
Install the new chain or wheel by slipping the chain
around the axle bolt. Slide the axle bolt into the
slots on the frame. Slide the chain tensioner down
and maneuver the chain onto the rear sprocket and
motor sprocket.
ATTENTION: Charge battery 12 hours before using.
RSF350 CHAIN
REPLACEMENT INSTRUCTIONS
PART # W15128040012
/