Anolis Ambiane™ User manual

Brand: Anolis

Model: Ambiane™

Category: Stroboscopes & disco lights

Type: User manual

User manual

Ambiane RGBW

The unit generates colored light by means of high power LEDs. The product was designed for indoor use only.

1. Attention

  Theunitmustbeinstalledbyaqualiedelectricianinaccordancewithall

national and local electrical and construction codes and regulations.

The unit was designed for indoor use only.

Avoid looking directly into the LED light beam at close range!

  Donotinstalltheunitnearhighlyinammableliquidsormaterials.

Do not allow anything to rest on the unit.

  Donotinstalltheunitnearanopename.

Do not install the unit in dirty,dusty or badly ventilated location.

  Sucientairaccessingtothehousingoftheunithastobeensured,

there must not be any heat or anti-noise insulation within a 0.6m x 0.6m

  areaaroundtheunit(non-ICratedxture).

Suitable for fastening on Unsuitable for covering by heat insulation

 non-ammablesurfacesonly  material

2. Installation

1.Prepareacircularopeninginthelowerceiling(1)asshowninthepicturebelow.

2.InserttheAmbianeunitintotheopening.Fastenthexturebymeansoftwospringfasteners(2)totheopening

Alvays switch o power suply of the unit before connecting or disconnecting the unit

Toconnectneededcablestothexture,unscrewtwoscrews(4)fromtheplasticcover(3)andchipneeded

plasticthin-walledcovers(6)oinordertopasscablestotheconnectionblocks(5).

Theconnectionblocks(5)havethefollowingwiring:

Theprimarypowerinputservesforastandardpower(e.g.ArcPowerforAmbiane).

Thesecondarypowerinputservesforabackuppower(incasethatprimarypowerfailed).

If both power inputs are under voltage, the primary power has a priority and the secondary power is disabled.

In case of primary power loss, the secondary power is enabled.

Ifthextureissuppliedviathesecondarypower,thelightoutputofthextureisawhitecolour(3200K)andits

light intensity can be set by a trimmer.

Thexturecanbecontrolledbyoneofthefollowingmethods:DMX512

DALI

ThextureisequippedwithtwoDMXandDALIconnectionblocksforeasyconnectiontoDMXorDALIchain

(In/Outmethod).

DMX connection Power connection

PCB Function PCB Function

0V - Shield + Power +

 D+ Signal(+)    - Power-

 D- Signal(-)

3. DMX and DALI address setting and control

TheDIPswitch,locatednexttotheconnectionblocks,allowsyou,runatestlightandswitchthexturetothe

update mode in case of software update.

DIP10-ifswitchedtoON=testlight(thexturelightsat3200K)

DIP11-hastobeswitchedtoOFFpositiontoreceiveDMX512orDALI

DIP12-changefromOFFtoONpositionswitchesthexturetotheupdatemode.

DMX control

TheDMXstartaddress,istherstchannelusedtoreceiveinstructionsfromtheDMXcontroller.Theaddress

maybeanychannelfrom1to509.DMXaddresscanbeseteitherbyDIPswitchorbyRDM.DMXaddress

setbyRDMoverwritesaddresssetbyDIPswitchandviceversa.ThegreenLEDonPCBsignalswayofDMX

addresssetting:

 LEDlights-DMXaddressissetbymeansoftheDIPswitch.

 LEDdoesnotlight-DMXaddressissetbymeansofRDM.

DIP 11 has to be set in OFF position.

ExampleofDMXaddresses:

DALI control

AddressingofthextureismadebymeansofanexternalDALIcontroller.TheexternalDALIcontrollerhasto

sendactivatingcommand(8=ON)ifyouneedtostartthepermanentcontrolofthexture(xturewillnotrespond

toDMXcommands)anddeactivatingcommand(0=OFF)tostopcontrolofthexture.

DIP 11 has to be set in OFF position.

Note:IfDIP11=OFF(xtureiscontrolledbyDMXorDALI),therstcomingcommandswitchesthexturetothe

correspondingoperationmode(DMXoperationbyaDMXcommand,DALIoperationbyaDALIcommand).E.g.

thexturestaysinaDALIoperationandcomingDMXcommandswitchesthexturetoDMXoperation.Next

commandisaDALIcommandandswitchesthexturetotheDALIoperationetc.Ifyouneedthepermanent

DALIoperation,youhavetosendaDALIcommand8tothexture.

4. RDM

ThisxturesupportsRDMoperation.RDM(RemoteDeviceManagement)isabi-directionalcommunication

protocolforuseinDMX512controlsystems,itisthenewopenstandardforDMX512devicecongurationand

status monitoring.

RDMallowsyoutosetaDMXaddress,selectDMXmodeandreadoutsoftwareversionofthexture.

5. Anti-glare ring installation

Inserttheanti-glarering(1)intothextureuntilthreelocks(2)snapintoslots(3).

6. Adapter ring installation

1.Removebothspringfasteners(2)byunscrewingthefourscrewsM4x10(1).

2.Slidetheadapterring(4)ontothehousingofthexture.Screwthenewfasteners(3)onthehousing.

UseoriginalscrewsM4x10(1).

7. DMX protocol

Version 1.1

Mode 1

Channel

Mode 2

Channe

Mode 3

Channe

Value Function Type of control

1 1 1

0-255

Red

RedLEDssaturationcontrol(0-100%) proportional

- - 2

0-255

Red Fine

RedLEDssaturationcontrolfrommin.-->max. proportional

2 2 3

0-255

Green

GreenLEDssaturationcontrol(0-100%) proportional

- - 4

0-255

Green Fine

GreenLEDssaturationcontrolfrommin.-->max. proportional

3 3 5

0-255

Blue

BlueLEDssaturationcontrol(0-100%) proportional

- - 6

0-255

Blue Fine

BlueLEDssaturationcontrolfrommin.-->max. proportional

4 4 7

0-255

White

WhiteLEDssaturationcontrol(0-100%) proportional

- - 8

0-255

White Fine

WhiteLEDssaturationcontrolfrommin.-->max. proportional

- 5 9

0-255

Dimmer

Lightintensitycoarse0%-->100% proportional

- 6 10

0-255

Dimmer Fine

Lightintensityfrommin.-->max. proportional

8. Technical specications

Inputvoltage:     24VDC

Protectionclass:    CE: (ClassIII)

      ETL:Class2orLVLE

Max.powerconsumption:   40W

Beamangle:     67°,80°,withanti-glarering

Control:     DMX,DALI,RDMcompatible

DMXchannels:     4(Mode1),6(Mode2),10(Mode3)

TypicalLumenmaintenance:   70%@50,000hours

Ledlifeexpectancy:    minimum50,000hours

Operatingambienttemp.range:  -20°C/+45°C(-4F/+113F)

Operatingtemperature:   75°C@Ambient+35°C(167°F@Ambient+95°F)

Totalheatdissipation:    136BTU/h(calculated)

Cooling:     convection

Totalheatdissipation:    136BTU/h(calculated)

Housing:     alluminium

Weight:     1.8kg

Installationmethod:    viatwospringfasteners

ICrating:     non-ICrated

Power/DMX/DALIconnection:   screwconnectionblockDegsonDG306-5.0-02P

      (Wirerange:22-14AWG(UL),1.5mm

(IEC))

Max.distancebetweenAmbianeand

ArcPowerforAmbiane:   1m(for2x18AWGcable)

Protectionfactor:    IP20(withoutdiuserglass),IP20/IP54(withDiuserGlass)

AmbianewithoutDiuserGlass    AmbianewithDiuserGlass

9. Optional Accessories

ArcPower for Ambiane

Anti-GlareRing(P/N10980386)

DiuserGlassFrosted(P/N10980387)

AdapterRing(230-255mm)(P/N10980388)

10. Maintenance

Keepthextureclean,especiallylightsourceandtheribbedhousing.

11. Dimensions

mm [inch]

Version2.1May11,2018

Specications are subject to change without notice.

Made in CZECH REPUBLIC by ROBE LIGHTING s.r.o. Palackeho 416/20 CZ 75701 Valasske Mezirici

Anolis Ambiane™ User manual

Brand: Anolis

Model: Ambiane™

Category: Stroboscopes & disco lights

Type: User manual

Download PDF

report

Anolis Ambiane™ User manual

Anolis Ambiane™ User manual

Related papers

Other documents