A
B
Head piece
2
Finial w/dowel screw
Step 4
Attach finials to top of post
A
B
Seat insert
Back insert
Short
brace
Seat frame
Long braces
4mm Hex Key for Drill: (INCLUDED)
9/17/2012
ASSEMBLY INSTRUCTIONS
A - 1/4-20 X 2-1/2 WAFER SHCS
4
B
NOTE:
Partialy thread both screws
into post before tightening.
Rocker bottoms may require some
flexing for proper fit.
Rocker bottom
Sideframe
Model: K147
Repeat step 2 on other side
Qty. Description
Step 3
Insert head piece into top of post
HARDWAREISCOATEDSTAINLESSSTEELUNLESSOTHERWISESPECIFIED
TOOLS NEEDED
__(1) Hardware pack
__(2) Sideframes
__(2) Rocker bottoms
__(1) Back insert
__(1) Seat insert
__(1) Seat frame
__(2) Long braces
__(1) Short brace
__(1) Head piece
Step 2
Attach long braces, short braces, seat frame and seat insert
to one of the sideframes using (5) .27x3” chair screws.
Attach back insert to sideframe using (2) 2½” chair bolts.
Note: Front of seat is wider
14
Step 1
Attach rocker bottoms to sideframes
using (4) .27x3 wafer screws.
B - .27 X 3 SOCKET WAFER A
4mm Hex Key, Allen, T-handle
(INCLUDED)
9/17/2012
ASSEMBLY INSTRUCTIONS
Step 1
Model: TWST, BST
Description
without pilot holes
Qty.
A screw gun is required
Phillips head screwdriver
__(1) Hardware pack
Uses (4) 8x3 screws
__(2) Leg assembly
by resting tray on the leg assemblies
8
TOOLS NEEDED
__(2) Trays
Attach a tray to the middle of the leg assemblies
Note:
Trays do not have pilot holes.
Screws go directly into Polywood
ALL HARDWARE IS COATED STAINLESS STEEL
A - 8 X 3 PHIL FLAT SCREW
Step 2
Attach other tray to the top of the leg
assemblies.
Uses (4) 8x3 screws
/
