Mellanox Technologies SX1410, Spectrum SN2700, SX1710 Quick Installation Manual

  • Hello! I am an AI chatbot trained to assist you with the Mellanox Technologies SX1410 Quick Installation Manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
www.mellanox.com
Mellanox Ethernet
1U Switch Systems
Quick Installation Guide
Models: SX1710, SX1410, SN2700
2
Pay Attention!
At least two people are required to safely mount the system in the rack.
All servers and systems in the rack should be planned with the airflow
direction. All FRU components must have the same air flow direction. A
mismatch in the air flow will affect the heat dissipation.
The part of the system to which you choose to attach the rails will
determine the system’s adjustable side. The systems part to which the
brackets are attached will be adjacent to the cabinet.
•The FRU side is extractable. Mounting the rack brackets inverted to the
FRU side will allow you to slide the FRUs, in and out.
Package Contents
•1 x System
Rail Kit for short depth (17”-24” / 432-610mm) or standard depth (24”-
34” / 610-863mm) racks
2 x Power cables – Type C13-C14
1 x Harness RS232 2M cable – DB9 to RJ-45
2 x Cable retainers
•Quick Start Guide
If anything is damaged or missing, contact your Mellanox representa-
3
Package Contents
8X
8X
4X
1X
1X
2X
2X
2X
2X
2X
Mellanox Technologies
4
1
2
Mellanox Technologies
5
3
4
Mellanox Technologies
6
5
6
7
Connector (Front) Side
FRU (Rear) Side
* It may take up to five minutes to turn on the system. If the System Status LED shows red after
five minutes, unplug the system and contact your Mellanox representative.
** Certain systems have a single management port.
LED Assignments
8
Configuration
1. Connect the host PC to the Console (RJ-45) port.
2. Configure a serial termin
al program.
Parameter Settings
Baud rate 115200
Data bits 8
Stop bits 1
Parity None
Flow control None
3. Log in:
OS Username Password
MLNX-OS admin admin
ONIE
a
a. No log in is required. Press Enter to activate the Console.
, 1
- -
4. Initial configuration
a. MLNX-OS: Go through the configuration wizard. For further information, please refer to:
http://www.mellanox.com/page/mlnx_os
b. ONIE
1
: Please refer to ONIE User Manual (www.mellanox.com-->Products--> Ethernet Switch Systems
-->SN2000 Series
For full installation instructions, go to http://www.mellanox.com/-->Products-->
Ethernet Switch Systems.
1. ONIE OS runs on top of SN2700/SX1710 switch systems only.
/