1of4
LightSourceToolsRequired
5BULBSREQUIRED
BULBSNOTINCLUDED
Warnings and Cautions
Turn off the electricity at the circuit breaker
before installation. Consult a licensed
electrician if in doubt about installation.
Turn off power to the fixture and allow the
bulbs to cool before replacing.
Crossbar Assembly
x1
A
Package Contents
PARTS BAG
Fixture Body
x1
Table of
Contents
FixtureHeightAdjustable
19.5”to49.5”
DCeiling Canopy
x1
Preparation: Identify and inspect all parts
before beginning the installation.
Missing or damaged parts? Contact your
original place of purchase.
D
F
Outlet Box Screw
x2
B
Wire Connector
x3
C
BULB BASE TYPE
Medium (E26)
BULB SHAPE
TYPE A
100W
MAX
6”L Rod
x4
12”L Rod
x4
G
Crossbar
Assembly
Rods &
Fixture Body Ceiling Canopy
STEP 1 STEP 2 STEP 3 STEP 6
Wiring
STEP 5
Bulb
STEP 7
Lanyard
STEP 4
Rods &
Ceiling Canopy
Installation Instructions: UQL3560Installation Instructions: UQL3560
www.urbanambiance.com
2of4
STEP 2 1 2 3
Step 1
Install crossbar assembly
Step2-3
Test fitting ceiling canopy to nipple
STEP 1
Optional Rods
8’ ceiling:
9’ ceiling:
10’ ceiling:
(2) 12”L rods
(4) 12”L rods
(4) 6”L + (4) 12”L rods
1
2
* Tighten slack cable*
(if necessary)
Install rods
www.urbanambiance.com
3of4
STEP 4
STEP 5
*Green Ground Screw on
crossbar optional
White wire (neutral)
from outlet box White wire
from fixture
Black wire
from fixture
Ground wire
from Fixture
Black or Red wire (hot)
from outlet box
Bare or Green ground wire
from outlet box
STEP 3 1 2
Separate Swivels from ceiling canopy
Install Swivels to upper rods
Reinstall swivels to ceiling canopy
3
www.urbanambiance.com
4of4
STEP 7
STEP 6
www.urbanambiance.com
/
