Too Cute Beads Moonlight Chain Linked Bracelet Kit User manual

Moonlight Chain Linked Bracelet Kit

Once you’ve unpacked your kit, begin by opening all

8 small jump rings, 6 aside, with your owlet, leaving 2

for your clasp at end of the bracelet.

Next, take your long piece of chain. You will need to

cut every 7th link until you have 6 small chain. Set

them aside with your owlet and jump rings.

Take 5 larger jump rings, open, and start a second

pile of components.

Next, we will cut the chain, but here, we need to cut

every 8th link until you have 12 chains. Add to the

area with your larger jump rings

Set the remaining chain into a ﬁnal pile with your

clasp.

Now we can begin to assemble.

Starting with a small jumping (from the owlet pile) add 1 chains (from the same pile) and take it through

your owlet and close.

Repeat 2 more times.

Now, take one of your large jump rings (from your second pile of components), and add the 3 chains

you’ve connected to your owlet making sure the links are not tangled. Then add 3 more chains (the

longer ones), and close your jump ring.

Take another large jump ring, repeat the process, but adding a small jump ring (There are additional

jump rings to extend the bracelet as needed. We suggest beginning with the larger jump ring and move

down as needed), and half of your clasp, and safety to the end.

Repeat for the other side of your bracelet.

Download PDF