ESAB Pressure Transducer Replacement Troubleshooting instruction

0558012673 06/2015

Pressure Transducer Replacement

The original pressure transducers supplied with this product are no longer available, thus it is

necessary to replace both transducers with a new mounting bracket to retain them.

1) Unplug the two existing transducers and remove from mount-

ing bracket.

2) Back out the two mounting screws until they are ush with the

inside of the mounting bracket.

3) Insert new transducers into mounting bracket as shown.

4) Install retaining bracket and re-tighten screws to secure.

Plug

Flush

Bracket