• Sanitise yours & your clients hands.
• Push the cuticles back with a cuticle pusher
• Remove any excess cuticles with cuticle nippers
• Using a 180/180 grit file, shape the nail.
• Etch the nail bed to remove any shine.
• Dehydrate & cleanse the nail bed with 100% acetone or a dehyrate product.
Nail preparation
1
STEP
Apply second layer of Cally Builder
• Starting at the cuticle, create a ball with your gel by swirling on the nail
bed, push up to the cuticle and pull down the sides, start to work the gel
down the nail building up a thicker layer to create an apex.
• Bring right the to the free edge and cap the ends.
• Cally builder is self levelling, gravity will help so turn hand upside down
for a few seconds and turn back.
• Cure 1 nail at a time to avoid product moving.
• Cure for 99 seconds on low heat mode.
REFINE
• Cleanse with lint free wipes to remove the tacky layer.
• Using a 180/180 grit file or 180 buer refine the nail bed,
smoothing it out.
• Make sure it’s thinner at the cuticle.
• Shape the free edge.
Step 5
Top coat or Gel polish
• Apply Cally NW Top coat, capping the free edge.
• Cure for 99 seconds on low heat mode.
• or Apply first coat of Gel Polish colour cure, then second coat cure. To
finish with Top coat ( refer to application of Cally Gel document if unsure)
• Finish with cuticle oil
Apply BASE COAT & first layer of Cally Builder
• Apply a thin layer of base coat to the nail bed and cure for 60 seconds
• Apply a thin layer of Builder gel to the nail bed, make sure you
cap the edge.
• Cure for 99 seconds on the low heat mode.
Application of Cally BUILDER Gel
2
2
STEP
3
STEP
4
STEP
5
STEP
