Air Water Life Aqua-Ionizer Pro Countertop Sink Kit Installation guide

Brand
Air Water Life
Model
Aqua-Ionizer Pro Countertop Sink Kit
Type
Installation guide
COUNTERTOP
INSTALLATION
(888) 601-5886
1. Turn off cold water line. Check to see that
it’s off by turning on faucet cold water.
2. Unscrew flexible cold water hose from
angle stop.
3.
Remove blue clip from appropriate T-fitting
and secure to water tap with thread seal tape.
4.
Attach cold water hose to end of T-fitting
5.
Insert faucet into hole on countertop with
rubber washer on counter to seal hole.
6.
Use large metal washer on top (if needed)
and large metal washer underneath to
secure to the countertop with nut.
COUNTERTOP INSTALLATION
Hand Tight Only
7. Remove blue Clip from push to connect
fitting and screw onto the metal post.
8. Insert hose into push to connect & T-fitting
9. Reattach Blue clips to t-fitting and push to
connect fittings.
10. Connect hose with red stripe preinstalled
on ionizer to top fitting of faucet.
11. Connect preinstalled hose near power cord
under ionizer to bottom fitting of faucet.
12. Turn cold water back on (counter
clockwise)
COUNTERTOP INSTALLATION
DUAL STAGE INSTALL
1. Complete countertop installation
2. Turn off cold water
3. Remove blue clip and hose from T-fitting and place
into either side of filters
4. Use new hose to connect to remaining side of filters
into T-fitting on cold water line.
5. Turn on cold water
Included Parts:
1x Small Metal Washer
Instructional Video Available
1x Push-to-connect
1x Nut
1x Faucet Rubber
2x Large Metal Washer
1x Rubber Washer
1x T-fitting
1x T-fitting
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

Air Water Life Aqua-Ionizer Pro Countertop Sink Kit Installation guide

Brand
Air Water Life
Model
Aqua-Ionizer Pro Countertop Sink Kit
Type
Installation guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Other documents