Tekkeon HARD CASE Operating instructions

Brand: Tekkeon

Model: HARD CASE

Type: Operating instructions

Instructions for Use

Place iPhone into the Case

1. Place iPhone in the bottom case plate.

2. Place the top plate over the top of

iPhone and press each side tab to

click into place.

Remove the Case

1. Starting at the

upper left corner

near the audio

jack, slide a

credit card in

the gap and

twist. The tab

will open.

2. Using the credit

card as leverage,

separate the

lower left tab.

The tab will open

and the cover

will pop off.

Continued on back

HARD CASE

WITH SOFT TOUCH

for iPhone

Twist

Separate

Tek_PT15xx_ug_1107_fnl_rev1 11/7/07 9:10 AM Page 1

Belt Clip Instructions

To Remove the Belt Clip

1. Push down on the

top lever to release

the clip, and pull the

clip downward.

2. To remove the mounting

screw, use a Phillips

screwdriver to remove

the screw from inside

the case.

To Add the Belt Clip

1. Place the provided mounting screw in

the hole on the rear of the case, and

insert the small screw from inside the

case. Tighten the small screw with a

Phillips screwdriver.

2. With the groove (shown) over the

screw, pull up until the clip snaps

into place.

Tekkeon, Inc.

3002 Dow Avenue, #134

Tustin, CA 92780

888-787-5888 / 714-832-1266

trademark of Apple Inc. Specifications are subject to

change without notice. 1107

www.tekkeon.com

Lever

Groove

Tek_PT15xx_ug_1107_fnl_rev1 11/7/07 9:10 AM Page 2

Tekkeon HARD CASE Operating instructions

Tekkeon HARD CASE Operating instructions

Tekkeon HARD CASE Operating instructions

Related papers

Other documents