Caution : You must read this before you proceed.
Storage Ottoman
1 of 4
Label Picture Description QTY
A Storage Ottoman 1
B Wooden Legs 4
Label Picture Description QTY
1 Washer Rings 7
Before Beginning Assembly:
2 of 4
Step 1
Step 2
Open the Carton Box and remove the Ottoman Storage and place onto a clean soft
surface.
Open the Ottoman Storage and you will see a box inside the Ottoman.
Remove this box from inside and place next to the Ottoman.
Open up this box and you will find 4 Wooden Legs.
UseofWasherRing
toalleviate
wobbleness andto
achieve evenness
Place the ottoman on its side, as shown above.
Install the first leg into the bottom of the Storage Ottoman by placing 1 (ONE) piece of
Washer Ring on the threaded stem.
The use of Washer Rings improves tightness and security of leg after assembly.
Tighten by turning the leg clockwise.
Repeat the same step to install the three remaining legs.
Note : The use of Washer Rings are OPTIONAL and is especially useful to help
alleviate slight wobbleness . Some Legs may need more than one whilst some legs do
not need any.
Step 3
Place the Storage Ottoman right side up, test for eveness.
Where you find this Storage Ottoman being uneven, identify the corresponding leg and
"add or remove" a Washer Ring to achieve evenness.
Turn the Ottoman the right side up and it is ready for use.
achieve
evenness
.
3 of 4
4 of 4
/
