Label Picture Description QTY
A
Storage Ottoman With Pre-
attached Legs
1
B Shelf 1
Label Picture Description QTY
①
Bolt (M8X45mm) 7
②
Washer 7
Caution : You must read this before you proceed
Storage Ottoman
Page 1 OF 6
③
Spring Washer 7
④
Allen Key 1
Before Beginning Assembly:
OVERVIEW
Shelf (B)
Storage Ottoman With
Pre-attached Legs(A)
FRONT FACING
Page 2 OF 6
Place the Storage Ottoman With Pre-attached Legs(A) facedown on a clean, non-marring
surface.
Unfold the Legs outwards until the Legs are at 90 degree angles with the Storage Ottoman
bottom as shown above.
This Storage Ottoman has multiple parts and may require up to some 30 minutes to
assemble. To give you an overview of the Ottoman parts, the above picture is to help you
put the various parts into perspective. Please read through the instructions herebelow to
familiarise yourself with the parts and steps before assembly.
Caution : Some parts are heavy, exercise safety and have adult assistants to help
whenever lifting and moving these.
Step 1
A
A
Page 3 OF 6
Step 2
Secure the Legs to the Storage Ottoman(A) using Bolts(①), Washers(②) and Spring
Washers(③) with Allen Key(④) as shown above.
Loosely tighten these bolts.
Turn the Storage Bench rightside up and test for wobbleness.
If there is no wobbleness, with the assistance from an adult partner, gently, turn it upside
down.
Now, in a sequential manner, loosely tighten bolts,.
Tighten the Bolts, in a sequential manner, until these are secure and firm.
Caution :DO NOT fully tighten one end to the other, tighten one end THEN the other,
THEN the middle, to avoid the product becoming wobbly.
A
①
③
②
④
Page 4 OF 6
Step 3
With assistance from your adult partner, stand the Storage Ottoman up.
Insert the Shelf(B) into the groove of the Storage Ottoman Leg from any side of the left and
right sides.
Have your adult partner hold the Shelf (B) in flat when Insertting.
Inspect and make sure all parts are connected, locked and fully secured into position.
Your Storage Ottoman is now ready for use.
This Storage Ottoman only be used on a flat, level surface.
Step 4
B
A
B
Page 5 OF 6
Page 6 OF 6
/
