Tier1 TIER1-FS-1004 User manual

Tier1
Brand
Tier1
Model
TIER1-FS-1004
Category
Water filters
Type
User manual

Tier1 TIER1-FS-1004 water filter effectively enhances your drinking water and ice quality for up to 6 months or 20,000 gallons. It combats bad taste, odor, chlorine cysts, cryptosporidium, and giardia, while also employing polyphosphate and KDF scale inhibitor to prevent scale buildup. Operating at a flow rate of 2 gallons per minute, this filter ensures a steady supply of clean, refreshing water.

Tier1 TIER1-FS-1004 water filter effectively enhances your drinking water and ice quality for up to 6 months or 20,000 gallons. It combats bad taste, odor, chlorine cysts, cryptosporidium, and giardia, while also employing polyphosphate and KDF scale inhibitor to prevent scale buildup. Operating at a flow rate of 2 gallons per minute, this filter ensures a steady supply of clean, refreshing water.

Tier1-FS-1004
FITS IN PLACE OF FILTERS:
Everpure
®
, Omnipure
®
QL2, QL3, QLL7I (Single Head)
FITS IN PLACE OF MODEL NUMBERS:
ELF-XL-1M-P-KDF, i20002, EV9612-22
FILTER USE: 6 MONTHS or 20,000 GALLONS, WILL VARY BASED ON WATER CONDITION
INSTALLATION:
1. Shut off water supply
2. Unlock and remove old filter cartridge
3. Insert and lock new cartridge filter into head assembly
4. Turn on water and check for leaks
5. If leaks occur, repeat step 3
6. Flush 5 gallons of water through new filter cartridge prior to use
7. Install in cold water applications only
8. Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the unit
9. Install in compliance of local and state regulations
WATER FILTER FEATURES:
For six months, this filter will produce great tasting
drinking water and ice by:
•
Reducing bad taste and odor
•
Reducing chlorine cysts, taste, and odor
• Reducing cryptosporidium and giardia
Filter Life: ....................6 months or 20,000 gallons
Flow Rate: .....................2 gallons per minute
Operating Pressure: ........max 125 psi
Operating Temperature:..40 - 100 degrees F
Filter Type: ............................Activated Granular Carbon Block
with Polyphosphate and KDF Scale Inhibitor
NOTE: This filter is to be supplied with cold water only, should not be installed on hot water systems. Installation shall comply with
applicable state and local regulations and should not be used with water that is microbiologically unsafe or of unknown quality,
without adequate disinfection before and/or after the filter.
FREQUENTLY ASKED QUESTIONS
Q: Why is my old water filter hard to get out?
A: The receiver has warped with heat and age. This usually occurs in filters left in service too long. Every seal in a Tier1
®
filter is pre-lubricated to aid in installation.
Q: Why are there black specks in the water or why does my water taste funny?
A: Water filters are made from the purest carbon blocks. When the filter ships it bounces around and knocks carbon
granules
loose from the block. These little carbon granules are called fines. All of the quality filters in the market place
require a
preliminary flushing to remove the carbon fines. Some systems may need to be flushed more than once. This is
especially true if
you have scale or lime water. If you go on vacation and do not use your filtered water for several days,
flush the systems
again to remove any stagnant water.
Q: If I do not change my filter every 6 months, can this damage the system?
A: Yes, you must replace the filter every six months or whenever the filter light comes on (whichever comes first), or sooner
if water flow to dispenser or icemaker is reduced or if there is heavy sediment/rust present. Filters left in longer will
fatigue and burst causing water damage. We recommend a water hammer arrester be installed in any home that uses a
refrigerator water filter.
UNCONDITIONAL PRODUCT GUARANTEE:
If you are dissatisfied with this product for any reason please contact the place of purchase. Please call Tier1 Technical Support, 1-855-378-
9116 with questions.
WARNING: To reduce the risk of property damage due to water leakage, this filter MUST be installed in accordance with the
manufacturer’s
specifications and instructions. This filter unit must be replaced every 6 months, at the rated capacity or sooner
if reduced water flow occurs.
Failure to follow instructions and operating specifications will void your warranty. Further, manufacturer assumes no responsibility or liability
for damages arising out of misuse of the product.
MADE IN USA
  • Page 1 1

Tier1 TIER1-FS-1004 User manual

Tier1
Brand
Tier1
Model
TIER1-FS-1004
Category
Water filters
Type
User manual

Tier1 TIER1-FS-1004 water filter effectively enhances your drinking water and ice quality for up to 6 months or 20,000 gallons. It combats bad taste, odor, chlorine cysts, cryptosporidium, and giardia, while also employing polyphosphate and KDF scale inhibitor to prevent scale buildup. Operating at a flow rate of 2 gallons per minute, this filter ensures a steady supply of clean, refreshing water.

Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents