Hubbell Wiring Device-Kellems PD1552 Installation guide

Hello! I've reviewed the installation instructions for the Hubbell PD1552 telephone connecting device. This document provides detailed steps for wiring the device, including information on stripping the wires, connecting them to the correct terminals, and tightening everything to the specified torque. I'm ready to answer any questions you have about the installation process or features of this device.
What should I do with the wire ends?

What are the wire to terminal connections?

What torque should I use for terminal screws?

What torque should I use for cord clamp screws?

PD1552 PRINTED IN U.S.A. 6/98

Wiring Device-Kellems

Hubbell Incorporated (Delaware)

185 Plains Road

Milford, CT 06460-8897

(203) 882-4800

THIS PRODUCT MEETS THE F.C.C. STANDARD FOR WEATHER-

PROOF OUTDOOR TELEPHONE CONNECTING DEVICES

ESTABLISHED JULY 12, 1976

Wiring Instructions:

1. Strip outside cable jacket back 1-1/4" then cut off 1/2" of green jacketed

conductor (black and

white conductors are

now 1-1/4" long and

green conductor is 3/4"

long).

2. Strip insulation on each

conductor back 1/2".

3. Loosen the three face

assembly screws and

remove the front portion

from the cord grip.

4. Loosen the cord grip

screws and slide the

cover down the cord.

5. Twist the strands of each wire into a tight bundle, leave no loose

strands. Do not tin or apply solder to wire ends.

6. Turn terminal screws counterclockwise to allow insertion of wire.

Wrap bare end of conductors under proper terminal screws.

Black Wire to R (Ring)

White Wire to T (Tip)

Green Wire to "GR" (Ground)

Tighten terminal screws 5-7 in.-lbs.

7. Slide cover up to wired interior assembly and tighten face assembly

screws 3-5 in.-lbs.

8. Tighten cord clamp screws 2-4 in.-lbs.