2. Hubbell Wiring Device-Kellems
  3. PD1970

Hubbell Wiring Device-Kellems PD1970 Installation guide

  • Hello, I've reviewed the Twist-Lock Instructions for Ring Terminals. This document provides essential information for safely installing twist-lock devices, including proper wiring procedures, terminal capacity, and use of copper wire. I'm ready to answer your questions about the installation process.
  • What type of wire should be used?
    What is the terminal capacity?
    Who should perform the installation?
Twist-Lock Instructions
PD1970 Page 1 PRINTED IN USA 9/03
®
Wiring Device-Kellems
Hubbell Incorporated (Delaware)
185 Plains Road
Milford, CT 06460-8897
(203) 882-4800
For use with Ring Terminals
General Information
1. CAUTION: RISK OF ELECTRIC SHOCK. Disconnect power before installing. For installation by a qualified electrician in accordance
with national and local electrical codes. Never wire energized electrical components
2. Use Copper Wire Only.
3. Check that the device’s type and rating are suitable for the application.
4. Select conductor size from National Electrical Code® Table 400-5 or Canadian Electrical Code Table 12.
5. Terminal capacity: #14 to 8 AWG.
Installation
Note: For use with UL Listed Ring Terminals Only.
1. Crimp proper wire to ring terminal per manufacturers instructions.
2. Insert ring terminal between terminal screw and terminal.
Tighten terminal screw 10-14 lb.in (1.1-1.6 Nm).
Twist-Lock Instructions
PD1970 Page 1 PRINTED IN USA 9/03
®
Wiring Device-Kellems
Hubbell Incorporated (Delaware)
185 Plains Road
Milford, CT 06460-8897
(203) 882-4800
For use with Ring Terminals
General Information
1. CAUTION: RISK OF ELECTRIC SHOCK. Disconnect power before installing. For installation by a qualified electrician in accordance
with national and local electrical codes. Never wire energized electrical components
2. Use Copper Wire Only.
3. Check that the device’s type and rating are suitable for the application.
4. Select conductor size from National Electrical Code® Table 400-5 or Canadian Electrical Code Table 12.
5. Terminal capacity: #14 to 8 AWG.
Installation
Note: For use with UL Listed Ring Terminals Only.
1. Crimp proper wire to ring terminal per manufacturers instructions.
2. Insert ring terminal between terminal screw and terminal.
Tighten terminal screw 10-14 lb.in (1.1-1.6 Nm).
/