2. Baso
  3. T36A1 Series

Baso T36A1 Series Installation guide

  • Hello! I've reviewed the provided instructions for the BASO thermopile BPG9. This document details the replacement procedure, emphasizing key points like securing proper flame impingement and ensuring the flame heats the thermopile tip correctly. I'm here to help if you have any questions about this process or the device itself.
  • What should I do before servicing the equipment?
    What should be done after replacing the thermopile?
    What to check after the light up the flame?
©2014 BASO Gas Products
Part No. BASO-INS-T36A1-1H Rev. - www.baso.com
Thermopile Instructions
Turn off the gas supply to the equipment
prior to servicing.
1. Disconnect the lead wire of the thermopile from the
gas valve.
2. From the pilot burner, un-screw the nut adapter or
pull out clip adapters.
3. Insert the new thermopile into the pilot burner and
attach either the nut or clip depending on the pilot burner.
4. Connect lead terminal to the gas valve.
5. Follow the lighting instructions from the original
equipment manufacturer.
a. stable flame with blue coloring
b. that the thermopile has correct flame impingement
c. the flame is heating the upper 3/8” of the thermopile tip
BASO thermopile replaces 600 - 750 millvolt
Honeywell and Robertshaw pilot burners
Replacement Step:
Pilot Burner
Assembly
BPG9
Thermopile
Clip
Nut
/