2. SMITH SYSTEM
  3. 179938

SMITH SYSTEM 179938 Assembly Instructions

  • Hello! I've reviewed the assembly instructions for the Smith System Elemental desks, specifically models 01475, 01476, and 01477. This document provides step-by-step guidance on how to assemble your new desk, including proper leg installation with a hammer and adjusting the height using set screws. I'm ready to answer any questions you might have about the process or components.
  • What needs to be checked before assembling?
    What is needed to assemble the product?
    How to clean the product?
For Assistance in assembling product, missing or damaged parts,
or to place an order, please contact customer service at 800-328-1061
You may also place your order online at
www.smithsystem.com
Form# 179938 04/2013
For Assistance in assembling product, missing or damaged parts,
or to place an order, please contact customer service at 800-328-1061
You may also place your order online at
www.smithsystem.com
Form# 179938 04/2013
Special Notes:
1. Check that all components are accounted for and undamaged before assembling.
2. Please assemble product in a clean and dry area.
3. For larger units, you may need another person to help assemble the product.
4. Clean the product with a mild cleaner and a damp cloth.
Tools Required:
1. Hammer
2. Wooden block or something to absorb direct impact of hammer
Hardware and Components
Replacement Hardware Pack:
1. 67612-R – EOB Dog Hardware Pack
a. (4) 77741 – 3/8-16x.625 Half Dog Socket
b. (4) 70054 – SM Screw #10x.75 Hi/Lo PTH
c. (1) 77813 – Hex Key – 3/16” Short Arm
Open Front Book Box attached to top
QTY: 1
Leg Insert
QTY: 4
Leg Stem
QTY: 4
3/16” Set Screw
P/N: 77741
QTY: 4
Hex Key 3/16” Short Arm
P/N: 77813
QTY: 1
For Assistance in assembling product, missing or damaged parts,
or to place an order, please contact customer service at 800-328-1061
You may also place your order online at
www.smithsystem.com
Form# 179938 04/2013
Assembly Instructions
Step 1: The leg stems are inserted into each of the 4 sockets of the
Plastic Box. The leg stem has a metal key which extends outward
slightly from the leg (Shown in Picture #1). The key must line up with
the slot on the plastic box.
**This step is crucial to leg installation.**
Step 2: With the leg stem aligned to the hole as provided in Step, the
leg must be hammered into place. Use a brace between the leg and
the impact of the hammer to protect the leg tube.
(A wood block is shown.) (See Picture #2)
With all 4 leg stems hammered into place, reassemble the leg
Insert into the leg stem, and use the set screws to set the height.
(as shown in Picture #4) Your Table is now ready for use.
Picture #1
Step 3: When the leg is fully set into place, the measurement
from the box to the top of the leg stem is 10 inches.
Picture #2
Picture #4
Picture #3
/