Bottom Tray
Silicone Pads
Clamp Arms
Grip Nut
Release Button
CATALOG
Overview............................................................... 02
Installation Steps.................................................. 04
Using Steps........................................................... 06
Specifications....................................................... 08
Attentions ............................................................. 08
EN
Overview
1. Take out the grip nut on the mount, assemble it with vent clip.
2. Find a suitable place in your automobile outlet, insert the car
mount.
Ball Joint
3-level Air Vent Clip
3-level Air Vent Clip Lever
1. Press the release button then the clamp arms open
automatically.
Using Steps
Screw Knob
Twist-lock Air Vent Clip
Ball Joint
2. Put the phone in the car mount then press the clamp arms to
grasp the phone.
3. After using, please press the release button again to open
the clamp arms and take out the mobile phone as shown in
the picture.
Specifications
Product Name
Model
Applicable Place
Package List
Car Mount
CTVK13
Air Vent
Car Mount ×1,
Air Vent Clip ×2,
User Manual ×1
The parameters above are derived from the laboratory of VANMASS®.
The actual parameters would be different because of products
and other factors. The image shown here is indicative only.
Attentions
●
Avoid dropping.
●
Do not disassemble.
●
Please install the car mount on a suitable place before
driving, do not operate and adjust the car mount during
driving.
●
Do not install the car mount in places which interfere with
airbag or driving.
●
Please do not twist the air vent clip too tight, to protect the
air vent blade.
●
Keep the car mount away from children.
Attention: To protect your
air vent blade, please adjust
the air vent clip properly
and do not use the air vent
clip too tight.
Installation Steps
horizontal and verticle
non-intensive, circular or special-shaped
Support
Nonsupport
The Suitability of Car Air Vent
02 03 04 01
06 07 0805
英语