Components Included
Desktop Panel (1PC)
Rails (2pc Thin, 2pc Thick) Made in China
Bottom Panel (1PC) Screws (8PCS) www.titan.fitness
Support Post (1PC) 1-800-605-8241
1.Insert the Rails: 2.Add the Desktop Panel: 3.Add the Rail Cap:
Tip the bottom panel on its side and screw
With the black clips facing up,side the
Fully lower the desktop panel.Then,
desktop panel onto the rails.
push the rail cap onto the four rails and
4.Adjust the Height: 5.Add the Support Post: 6.Lower the Desk:
Holding the desktop panel with two hands,
The Support Post works the same as a
To lower the desk, first remove the
slide it up to your comfortable working
tension rod. Twist the metal parts of the
Support Leg.Holding the top with both
height .While still holding it,use your
Support Post away form each other,
hands,use your thumbs to unlock the
thumbs to lock the black clips.
move them to your desired height,and
black clips.Then, slowly glide the desk
then twist them back until they lock.
down the rails to the bottom.
Tip: Use a permanent marker to mark
your height so you can reset your desk
Desktop slides down: Support Leg:
Make sure the clips are fully locked.
If the Support Leg does not hold, make
sure you have tightly twisted the metal
tubes to adjust the height.You should
not be twisting the end cap to adjust
NEED HELP?
CONTACT US FIRST
1(800)-605-8241
Business hours:
Monday - Friday • 8am - 5pm Central
Assembly Instructions
Trouble Shooting
Open
Locked
Adjust Here
Do Not Adjust Here