INSTRUCTION MANUAL
Product Diagram
What’s in the box?
Thank you for purchasing the GoCharge USB Power Pack. This easy-to-use,
multi-functional charger lets you charge your USB powered devices ON-THE-
GO! Its dual charging USB ports charge two devices at once while in the car,
and its powerful internal backup battery stores extra power for when you are
away from outlets. Charge it up by AC, DC, or USB and you are good to GO!
Never let a dead battery stop you again…
a - GoCharge USB Power Pack
b - MicroUSB Cable
c - MiniUSB Cable
d - USB Cable for iPhone and iPod
e - USB-AC Adapter
1 - Battery meter
2 - Battery meter button
3 - Power switch
4 - Power LED
5 - DC barrel cover
6 - DC barrel
7 - LED ashlight
8 - LED light button
9 - Dual USB charging ports
10 - Mini port
fig. 1
1
2
3
4
5
6
7
abcde
8
9
10
fig. 2
Charging the GoCharge Power Pack
In the Car
The GoCharge Power Pack is equipped with a ip out (6) DC barrel for car
charging.
Slide back the (5) DC barrel cover and ip-out the (6) DC barrel. Plug the (6) DC
barrel into your DC car outlet and you will see the (4) Power LED glow BLUE to
indicate power ow.
At Home
The GoCharge Power Pack can be charged by an AC wall outlet.
Simply connect the (c) MiniUSB cable to the (10) Mini port. Then, connect the other
end of the (c) MiniUSB cable to the (e) USB-AC adapter. Plug the (e) USB-AC adapter
into an AC wall outlet and the backup battery will begin to charge.
By USB Port
You can recharge the GoCharge Power Pack using any standard USB charging
port found on laptops, computers and other USB charging devices.
Simply connect the (c) MiniUSB cable to the (10) Mini port. Then, connect the
other end of the (c) MiniUSB cable to the USB port on your computer or other USB
charging device.
Operating Instructions:
Using the GoCharge Power Pack for ON-THE-GO Charging
LED Flashlight Function
Using the GoCharge USB Power Pack as a Dual Car Charger
The GoCharge Power Pack has a 2000mAH backup battery which enables you
to charge a single USB device without being plugged into an AC or DC outlet. It
also comes with 3 USB charging cables for the most popular digital devices: (b)
MicroUSB Cable, (c) MiniUSB Cable, and (d) USB cable for iPhone® and iPod®.
You can check the GoCharge Power Pack’s backup battery level by pressing the
(2) Battery meter button. The (1) Battery meter is easy to read with four RED bars
that indicate low, medium, and high power levels. If all four bars are illuminated
red, the GoCharge Power Pack is fully charged ( g. 3).
Slide the (3) Power switch to ON. The (4)Power LED will glow BLUE indicating that it
is ready to charge your mobile device. Simply connect the appropriate USB cable
to one of the the (9) Dual USB Charging ports, and then connect the other end to
your mobile device.
Note: If you’re not using the backup battery to charge your mobile device, please
slide the (3) Power switch to OFF.
Press the (8) LED light button to turn ON the (7) LED ashlight. Press it again to turn
OFF the (7) LED ashlight.
The GoCharge Power Pack is equipped with (9) Dual USB charging ports so you
can charge up to two USB devices at once while in the car.
Simply connect one or both of your devices to the (9) Dual USB charging ports.
Slide back the (5) DC barrel cover and ip-out the (6) DC barrel. Plug the (6) DC
barrel into your DC car outlet and you will see the (4) Power LED glow BLUE to
indicate charging.
Checking the Battery Meter
Display Life
25%
50%
75%
100%
fig. 3
None of the bars on the (1) Battery meter are glowing RED when I press the
(2) Battery meter button. Also, the (7) LED ashlight does not light when
pressing the (8) LED light button.
- The GoCharge Power Pack’s backup battery has no power and must
be recharged.
The GoCharge Power Pack is connected to the (e) USB-AC adapter and
plugged into an AC wall outlet but won’t charge my USB device.
- AC power does not support dual USB charging. While charging the
GoCharge PowerPack’s backup battery via AC wall outlet, you must let it
absorb power for at least 15 minutes. Afterwards, go ahead and connect the
device and slide the (3) Power switch to ON. Your mobile device will begin to
draw power.
Troubleshooting
Product Speci cations
Input by DC car outlet: DC12V~DC24V
Input by Mini port: DC5V±5%
USB Output with DC car outlet: DC5V±5%, 1000mA
USB Output with backup battery: DC5V±5%, 500mA
Capacity of battery: 2000mAH
Recharging time: 3.5 hours
LED Flashlight time: About 40 hours on one charge
Dimensions: 3.35”(L) x 2.4”(W) x 1.18”(H)
- Keep in a safe place free from dust, liquid and extreme temperatures
- Only use this device with the recommended power sources
- Keep out of reach of small children
- When not in use, please disconnect from any power sources
Cautions
©
2010 ACCESSORY POWER
All trademarks and brand names are the property of their owners
iPhone, iPod, iPod classic, iPod nano, and iPod touch are trade-
marks of Apple Inc., registered in the U.S. and other countries.
Apple is not responsible for the operation of this device or its
compliance with safety and regulatory standards.
/
