IMPORTANT SAFETY INSTRUCTIONS
Item #: WORK500LZBAT
Portable Work Light with Laser Level
PARTS OF THE WORK LIGHT
MAINTENANCE
Questions, problems, missing parts? Before returning to the store,
call Feit Electric Customer Service
8 a.m. - 5 p.m., PST, Monday - Friday
We appreciate the trust and confidence you have placed in Feit Electric through the purchase of this LED Portable Work Light. We strive to continually create
quality products designed to enhance your home. Visit us online to see our full line of products available for your home improvement needs.
Thank you for choosing Feit Electric.
1-866-326-BULB (2852)
FEIT.COM
Power
COB Light
Disk Bubble
Levelers
(one on each side)
USB
Charge Port
Center Bubble
Leveler
Center Bubble
Leveler
Powerful Magnet
Disk Bubble
Leveler
Laser Flashlight
1
SAVE THESE INSTRUCTIONS
WARNING: To reduce the risk of injury, read and
understand the owner's manual before using this product.
WARNING: Failure to observe the following safety rules
may result in FIRE, ELECTRICAL SHOCK, OR INJURY.
Maintenance of this work light is very minimal. Regularly clean the lens with a non-abrasive
cleaning cloth.
Always be aware of the location of use when using the laser. Always make sure
surrounding bystanders are aware of the danger of this laser.
Do not leave the laser work light carelessly unattended or in a position where
anyone can unintentionally stare at this light.
Always leave laser light off when not in use
Do not operate laser light in combustible or flammable areas.
Always make sure laser is not aimed on a reflective surface.
Do not use in wet locations.
Do no crush or incinerate.
•
•
•
•
•
•
•
Press the power button to cycle through the different light modes:
• Mode 1: Main light 500lm
• Mode 2: Torch Light 80lm
• Mode 3: Laser light+ Leveler light
• Mode 4: Laser light + Leveler Light+Torch light
2Using the laser level:
• Always make sure the laser beam is off when being mounted.
• The center bubble leveler allows for horizontal leveling.
The two disk bubble levelers allows for horizontal and vertical
Leveling. Must be on the flat side up against the wall (see Fig. 1).
3
Mounting with a magnet:
• Attach the magnet to a clean metal surface.
• Use the built-in levelers to adjust the unit.
• Go into MODE 3 to project the laser beam. If in a low lit
environment MODE 4 provides a torch light and leveler light.
• Make sure work light sits flat on the surface for better accuracy.
• Do not tamper with levelers or body of work light to obtain the
best results.
NOTE: The laser guide radiation used in this leveler is class llla
<5mW and 650nm wavelength. These lasers do not present an optical
hazard although staring at this light will cause flash blindness. Avoid
Direct eye exposure when using the laser and do not project this light
into any ones eyes. Do not remove or alter the product labels.
Removing the labels increases the risk of laser radiation.
FUNCTIONALITY
Magnet
(on bottom)
Fig. 1
-
1
Feit Electric Portable Work Light User manual
- Type
- User manual
- This manual is also suitable for
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Other documents
-
Midmark Vantage Panoramic X-ray System Installation guide
-
-
-
-
-
-
-
-
3D Systems ProX 800 User manual
-