Elizabethan Classics ECRM24 ORB Installation guide

ECRM24 ORB
Elizabethan Classics
Brand
Elizabethan Classics
Model
ECRM24 ORB
Category
Sanitary ware
Type
Installation guide

This manual is also suitable for

Assembly Instructions for 3V3LSA
NOTE: USE TEFLON TAPE ON ALL THREADED CONNECTIONS
1. Shut off the water supply valves before installation.
2. According to your requirement, connect the riser or swivel arm connector kit to the faucet body.
3. Attach the diverter lever onto diverter valve and tighten the diverter screw.
3. Install handles. After installation is completed. Turn on the water supply valves and allow both hot
and cold water to run at least one minute each. While water is running. Check for leaks,
especially at hook-ups to supply lines. Tightening nuts slightly will stop any minor leaks.
Diverter lever
Diverter screw
Lever Handles:
1. Be sure that the broach screws are tightened installing the lever handles.
2. Install the lever handles on the broaches and tighten the set screws using the allen
wrench provided.
before
Cross Handles:
1. Remove the screws from the top of the broaches.
2. Remove the insert caps from the cross handles.
3. Put the cross handles on the broaches and then tighten the screws. Insert the caps on the
cross handles.
Broach
Broach
Screw
Set
Screw
Allen
Wrench
Assembly Instructions for Handles
Rev.D
Elizabethan
Classics
R
NOTE: TO BE INSTALLED ONLY BY QUALIFIED, LICENSED PLUMBER
CAUTION: DO NOT OVER TIGHTEN NUTS AND SCREWS - THIS CAN LEAD TO
STRIPPING OR CRACKING AND WILL VOID YOUR WARRANTY.
RM21-25
Assembly Instructions for 6RMN
NOTE: USE TEFLON TAPE ON ALL THREADED CONNECTIONS
1. Shut off the main water supply valves before installation.
2. Thread the Brass Nipple into Supply Shank.
3.Insert Rubber Washers into Coupling Nuts. Thread faucet onto
90 degree elbow and tighten the Coupling nuts.
4. .
5.Tighten the Mounting Nuts.
6.Place Supply Line Nuts, Friction Rings, and Cone Washers onto
supply line coming out from floor. Connect the Brass Nipples and
tighten wrench tight. CAUTION:
Get Brass Nipples through the faucet holes
DO NOT OVERTIGHTEN.
Elizabethan
Classics
R
Rev.A
90 degree elbow
CAUTION: DO NOT OVER TIGHTEN NUTS - THIS CAN LEAD TO
STRIPPING OR CRACKING AND WILL VOID YOUR
WARRANTY.
NOTE: TO BE INSTALLED ONLY BY QUALIFIED, LICENSED PLUMBER
Brass Nipple
Tub Deck
Mounting Nut
Cone Washer
Friction Ring
Supply Line Nut
Faucet Hole
Coupling Nut
Rubber Washer
Supply Shank
NOTE : REQUIRE ECSSL STRAIGHT BATH SUPPLY LINES WHICH
INCLUDE SUPPLY LINE NUTS, FRICTION RINGS, AND CONE
WASHERS.
Faucet
Rev.E
Elizabethan
Classics
R
NOTE: TO BE INSTALLED ONLY BY QUALIFIED, LICENSED PLUMBER
NOTE: USE TEFLON TAPE ON ALL THREADED CONNECTIONS
CAUTION: DO NOT OVER TIGHTEN NUTS - THIS CAN LEAD TO STRIPPING OR
CRACKING AND WILL VOID YOUR WARRANTY.
AND SCREWS
RM21-25
  • Page 1 1
  • Page 2 2
  • Page 3 3

Elizabethan Classics ECRM24 ORB Installation guide

ECRM24 ORB
Elizabethan Classics
Brand
Elizabethan Classics
Model
ECRM24 ORB
Category
Sanitary ware
Type
Installation guide
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents