ANSMANN RC 1 Operating instructions
- Category
- Flashlights
- Type
- Operating instructions
This manual is also suitable for
ANSMANN RC 1 is a rechargeable Krypton bulb torch with magnet that enables it to stick to any magnetic surface while in use. Powered by a 2.4V NiMH battery pack with a 1200mAh capacity, this torch operates for up to 120 minutes. It comes with a blue carrying strap and a 230V power supply, with integrated charging electronics and battery pack.
ANSMANN RC 1 is a rechargeable Krypton bulb torch with magnet that enables it to stick to any magnetic surface while in use. Powered by a 2.4V NiMH battery pack with a 1200mAh capacity, this torch operates for up to 120 minutes. It comes with a blue carrying strap and a 230V power supply, with integrated charging electronics and battery pack.
Page is loading ...
OPERATING INSTRUCTIONS
USE OF THE TORCH
The RC 1 is a rechargeable torch with krypton
bulb (KR 2.2V/0.5A/P13.5). It is powered by a
2.4 V NiMH battery pack with 1,200 mAh and
can be recharged direct at any 230 V mains
socket. The magnet allows the torch to be stuck
to any magnetic surface.
CHARGING
Charge the torch before using it for the first time.
To charge, remove the complete bottom part of the
lamp (consisting of battery pack, charging electro-
nics and power plug) from the slot. Connect it to
a 230 V mains socket. The integrated recharge-
able battery pack is then being charged with a
charging current of approx. 120 mA. The char-
ging time up to the maximum charge is around
10 hours. The battery pack can be left attached
to the mains until the torch is needed. The lamp is
charged continuously to avoid losing capacity.
OPERATING TIME
The operating time of the RC 1 torch is around
120 minutes.
OPERATION
If you want to use the torch, disconnect the bat-
tery pack from the mains. By pushing the slide
switch towards the head of the lamp, the torch is
switched on. The integrated magnet at the lower
part of the torch allows the lamps to be stuck to
metallic surfaces when in operation.
Attention: The bulb is sensitive to shocks.
If the lamp drops, the thin lighting fila-
ment in the bulb may break. Please re-
charge the lamp early enough when in
use. Never leave the lamp switched on
with empty batteries as this may cause
damages to the battery pack.
REPLACING THE BULB
Turn the head of the torch anticlockwise and
remove the reflector and the bulb. The bulb
can now easily be replaced. A spare bulb is
attached to the inside of the lamp head.
ACCESSORIES
Includes: blue carrying strap, 230 V power supply.
Charging electronics and 1,200 mAh/2.4 V batte-
ry pack are integrated in the torch. A mains adap-
tor plug for UK is available as special accessory.
WARNING
Protect against high humidity and wa-
ter. Do not expose to extreme temperatures.
Do not clean and maintain the torch during the
charging process. To clean the lamp only use a
damp cloth. In case of a defect do not dismantle
the torch or charger, but return it to an authori-
sed dealer.
ENVIRONMENTAL REFERENCE
Rechargeable batteries are not to be disposed
of via domestic refuse, but returned to dealers or
battery collecting points.
ANSMANN RC1 (Part No. 5101103)
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
-
1
-
2
-
3
-
4
-
5
-
6
-
7
-
8
-
9
-
10
-
11
-
12
-
13
-
14
-
15
-
16
-
17
-
18
-
19
-
20
-
21
-
22
-
23
-
24
-
25
-
26
-
27
-
28
-
29
-
30
-
31
-
32
-
33
-
34
-
35
-
36
-
37
-
38
-
39
-
40
-
41
-
42
-
43
-
44
-
45
-
46
-
47
-
48
ANSMANN RC 1 Operating instructions
- Category
- Flashlights
- Type
- Operating instructions
- This manual is also suitable for
ANSMANN RC 1 is a rechargeable Krypton bulb torch with magnet that enables it to stick to any magnetic surface while in use. Powered by a 2.4V NiMH battery pack with a 1200mAh capacity, this torch operates for up to 120 minutes. It comes with a blue carrying strap and a 230V power supply, with integrated charging electronics and battery pack.
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
in other languages
- italiano: ANSMANN RC 1 Istruzioni per l'uso
- français: ANSMANN RC 1 Mode d'emploi
- español: ANSMANN RC 1 Instrucciones de operación
- Deutsch: ANSMANN RC 1 Bedienungsanleitung
- русский: ANSMANN RC 1 Инструкция по эксплуатации
- Nederlands: ANSMANN RC 1 Handleiding
- dansk: ANSMANN RC 1 Betjeningsvejledning
- polski: ANSMANN RC 1 Instrukcja obsługi
- čeština: ANSMANN RC 1 Operativní instrukce
- eesti: ANSMANN RC 1 Kasutusjuhend
- svenska: ANSMANN RC 1 Bruksanvisningar
Related papers
-
ANSMANN 5816162 Operating instructions
-
ANSMANN 5026013 Datasheet
-
ANSMANN Energy 4 Speed Operating instructions
-
ANSMANN T400FR User manual
-
-
ANSMANN Powerline 8 User manual
-
ANSMANN Energy 8 Plus Operating instructions
-
-
ANSMANN ASN 15HD+ Operating instructions
-
Other documents
-
HQ NIMH-2VR011 Datasheet
-
StarTech.com NF05D1200P Datasheet
-
Stanley 1-95-154 Owner's manual
-
GYS PORTABLE TRIPOD HAND LAMP (250L) Owner's manual
-
-
Falcon Eye FBF0114 Operating instructions
-
Facom 779.1000RPB Owner's manual
-
XD-Design P513.601 Operating instructions
-
-
LIVARNO 113950 Owner's manual
