Gorilla Gadgets JungleConcert Premium User manual

Brand: Gorilla Gadgets

Model: JungleConcert Premium

Category: Bluetooth music receivers

Type: User manual

This manual is also suitable for

JungleConcert

GORILLA GADGETS

JungleConcert

Premium Bluetooth

Headphone

User Guide

Table of Contents

1. Introduction 3

2. Safety 3

3. Package Contents 4

4. Control Diagram 4

5. User Guide 5

5.1 General Use 5

5.2 Pairing to a mobile phone or other Bluetooth

–enabled device 7

5.3 Pairing to a computer 8

5.4 Wired Line-in Input 8

5.5 USB Audio Input 8

5.6 Charging your JungleConcert

Stereo Headphone 9

7. Service and Support 10

8. Frequently Asked Questions (FAQ’s) 10

1. Introduction

Whether you’re in the rain forest or deep in the urban jungle, you’re

going to love your new JungleConcert

Bluetooth

Stereo

Headphones. This brief instruction manual will help you become

familiar with all the features that are built into your headphone, and we

strongly advise you to read it before attempting to connect. But if

you’re like 99% of the other gorillas out there, you’ll pop open the

package, go as far as you can, and then check out this booklet when you

get stumped. That’s OK, too, but don’t say we didn’t tell you so…

2. Safety

It’s like, really hard to hurt yourself with a battery-driven stereo

headphone, but someone will figure out a way, so we’re going to tell you

the obvious here:

1) Read the manual before you use the headphone. It has a lot of

good information in it.

2) Watch for sharp edges, uneven surfaces, or metal parts that could

scratch or cut you.

3) Don’t try to modify, repair, or dismantle this headphone. Doing so

could result in fires, electric shocks, complete destruction of the

headphone or worse, all of which will not be covered under your

warranty. So don’t do it. Send it to us if it’s under warranty, and

we’ll either replace it or repair it for you.

4) Don’t use solvents or volatile liquids to clean your JungleConcert

headphone.

5) Don’t use your JungleConcert Headphone in any area that could be

considered hazardous – especially those areas where you need to

be hearing what’s going on around you.

3. Package Contents

• JungleConcert Bluetooth

Stereo Headphone

• USB Charging Cable

• Audio Cable

• User Manual

• Carrying case

4. Control Diagram

5. User Guide

5.1 General Use

To do this:

Follow these instructions:

Turn on

Press the MFB button for 3 seconds when the device is

off. A pink LED will slowly flash and you’ll hear a tone

beeping.

Enter the Pairing

Mode

Press the “+/-“ button with the power on, and hold it for 6

seconds. A white and red LED will alternately flash and

you’ll hear a two beep tone.

Pairing

You can pair with your mobile phone or any other Bluetooth

enabled master device

Turn Off

Press the MFB button for 3 seconds when the device is in

the ‘on’ mode. You’ll hear a tone beep and all the LED lights

will go off.

Low Battery

Warning

The red LED will flash continuously.

Charging

Plug your USB (supplied) cable into the built-in port

Answer a Call

Touch the MFB button when you know there’s a call coming

in.

End a Call

Same thing. Touch the MFB button and you’ll disconnect

the call.

Shift between

two devices

Double press the MFB button to transfer from one device to

another; ie.to answer a call or to go from a call to another

device.

Reject a call

Press the MFB button for 1-2 seconds to reject an incoming

call.

Volume Up

A short press on the “+” button will take the volume up a

notch.

Volume Down

A short press on the “-“ button will knock the volume down

a notch.

A short press on the “>” button will advance you to the next

selection.

A short press on the “<” button will take you back to the

previous selection

Battery Power

Indication

When you pair to an iPhone, the battery power on your

headphone will be indicated on your iPhone.

Play/Pause

A short press of the “>” key will play or pause the music

when your headphone is connected.

Multi-point

Connection

In pairing mode, short press the “>” button to enable the

multi-point option; double press the MFB to disable the

multipoint option.

Factory Reset

Long press both “>” and “<” when you’re in the pairing mode

to reset or clear the paired device list.

5.2 Pairing to a mobile phone or other Bluetooth

–enabled

device

To use your JungleConcert Bluetooth

Headphone, you must first pair your

headphone with a phone or a computer that is also Bluetooth

enabled. Once

your headphone is paired to a specific phone or computer, it will remain paired

and will automatically recognize each other whenever they are within range.

1) Turn on your phone and make sure the Bluetooth

function has been

activated

2) Turn on your JungleConcert Headphone and go to the pairing mode

3) Search the list of Bluetooth

devices available on your phone by

following your phone’s instructions. Refer to your phone’s instruction

manual if you still have it.

4) After a few seconds, the phone will detect the JungleConcert

headphone as a ‘discovered’ device. Select it, and follow your phone’s

instructions to select this particular pairing.

5) Your phone may request a Passkey or PIN; enter 0000 as your PIN or

Passkey.

6) Your phone will confirm the pairing. Press ‘Yes’ or ‘OK’ if it asks.

Select the option to connect with the device from your phone’s

screen.

7) You can play music, watch TV or a movie, or play games on your phone

while listening to the audio on your JungleConcert Stereo Headphones.

You can control the audio from the headphone using the touch control

panel on the side.

5.3 Pairing to a computer

1) Make sure your computer is Bluetooth

enabled. If it is not, you will

need to acquire a Bluetooth

adapter. Once it is in place, make sure

the Bluetooth

function is activated.

2) Turn on your JungleConcert Headphone and go to the pairing mode

3) Open the Bluetooth

software that is installed on your computer, and

then select the option that searches for Bluetooth

devices. Refer to

the software manual if you still have it.

4) After a few seconds, the name of your device will be listed on your

computer as a ‘discovered device”.

5) Select the device’s icon and click the right-side button on your mouse

to choose the ‘Pairing’ option; then select “connect with audio device”.

6) Go to your media player, or whatever program you want to transfer the

audio from, and listen in complete privacy to the clean, clear sounds.

5.4 Wired Line-in Input

Your JungleConcert Stereo Headphone supports a 3.5mm audio jack

line-in cable if you should desire to go that way. The only reasons we

can think of are if the batteries go low, or if wireless devices aren’t

permitted wherever you are. When you use the line-in cable, the

Bluetooth

option will automatically power off.

5.5 USB Audio Input

You can charge your JungleConcert Stereo Headphone and listen to

music at the same time when you connect it with the USB cable to your

computer.

5.6 Charging your JungleConcert Stereo Headphone

Your Headphone uses a USB – to – Micro USB charger. Make sure that

your JungleConcert headphones are fully charged (at least 6 hours)

before your first use. When the headphone is charging, you’ll see a red

LED light in the constant ‘on’ mode. When charging is complete, the red

LED will go off, and a white LED will go on.

Warning:

You must fully charge your JungleConcert Headphone if it has not

been used for more than 12 months.

6. Technical Specifications

7. Service and Support

If you believe your JungleConcert Headphone is not working

properly, please contact Gorilla Gadgets Customer Service. Our

contact information is available at www.gorillagadgets.com.

8. Frequently Asked Questions (FAQ’s)

The headphone doesn’t show any power, even when it’s

turned on.

Make sure you’ve charged the battery for up to 6 hours

when you use it for the first time. The LED will be a solid

red while charging, and will turn white when it’s done

charging.

There is no sound coming from my headphone

Check the connection between your headphone and your

phone or computer/laptop. If the connection is not

established, follow the instructions to reconnect. Make

sure the headphone is paired or connected with your

target phone or other master device.

I can’t seem to connect the headphone to a second device

Set the headphone to ‘pairing mode’, and do a short

press on the “>” button to multipoint mode. Connect the

headphone to phone #1. Press the “+” and “-“ buttons

for 6 seconds to enter the pairing mode again and then

connect the headphone to phone #2. Then use phone

#1’s paired device list to reconnect to the headphone.

Gorilla Gadgets JungleConcert Premium User manual

Brand: Gorilla Gadgets

Model: JungleConcert Premium

Category: Bluetooth music receivers

Type: User manual

This manual is also suitable for

JungleConcert

Download PDF

report

Gorilla Gadgets JungleConcert Premium User manual

This manual is also suitable for

Gorilla Gadgets JungleConcert Premium User manual

Other documents