Genius HS-920BT User manual

Genius
Brand
Genius
Model
HS-920BT
Category
Bluetooth music receivers
Type
User manual
ENGLISH
General Functions:
Function
Required Action
Turn on
Press the “
” button for
three
seconds when the
device is off. (Blue LED slowly flashes with a tone
.
Enter the
pairing mode
In
power off mode
, p
ress the “
” button and
hold on for six seconds.(Blue LED and Red LED
quickly flash alternately with two tone beeps).
Pairing
In pairing
m
ode
,
use a Bluetooth function mobile
phone or other Bluetooth device to perform
pairing action.
Play / pause
Press
to play when the device is paus
ed
and
press to pause when the device is playing.
Volume up
Press + for volume up
.
Volume down
Press
-
for volume down
.
Previous
Press
for previous
song.
Next
Press
for next
song.
Turn off
Press
the “
” button for
three sec
onds when the
device is on (a tone beep and all LEDs are off).
Low battery
warning
LED flash
.
Charging
Plug the charger to port of the device.
(Red LED is
on)
.
Answer call
Press “
” button for
one
second
for in
coming
call.
End call
Press “
” button for
one
second to end
c
all
.
Transfer call
Press “
-
” button for
two
seconds to transfer the
voice
voice
ca
l
l
between the mobile phone and device
.
Reject call
Press “
” button for
two
seconds to reject call
when the call is
ringing
.
Pairing to a phone
1. Turn on your phone and ensure its Bluetooth function is activated
2. Turn on the Bluetooth Stereo Headphone and go to the pairing
mode.
3. Search your Bluetooth devices on your phone by following the
phone's instructions.
4. After a few second the phone will list the device as a discover
device. Select it and follow your phone instruction to select this
pairing.
5. Then your phone will request a passkey or PIN, enter 0000 as your
PIN or passkey.
6. Your phone will confirm the pairing, and press Yes/Ok.
Charging your device
The device is convenient to connect to an AC charger or a USB
charger with the Micro USB cable. Make sure that your device is fully
charged for at least six hours before initial use. Insert one terminal of
your charger to the AC main or USB port of PC and other terminal to
the Micro USB. While charging, the red LED will be lit constantly.
When the charging is completed, the LED turns off.
Reset the headset
In the pairing mode, press “-” button and “ ” for six seconds to
return to the default setting.
  • Page 1 1
  • Page 2 2

Genius HS-920BT User manual

Genius
Brand
Genius
Model
HS-920BT
Category
Bluetooth music receivers
Type
User manual
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents