Olympia MR-228A User manual

MR-228A Controller Manual

Version:V3.9

MingRui Technology Co., Ltd.

Revised Date:2022/01/21

Beijing Mingrui Lighting Technology Co., LTD

Address: Room 1105,Ruidu International Center, No.78, Jiukeshu West Road, Tongzhou District, Beijing

Postal code: 101100

Tel: 010-80816559 fax: 010-80816559-810 Website: www.bj-mrkj.com 2/10

Overview

I. Features

1. MR-228A Support TTL Serial Zero Code Protocol a and Multi-Chip Selection；

2. The Output is Compatible With the TTL Level Signal and Differential Signal Dual Mode;

3. MR-228A Support infinite Cascading Transmission Without any Cascade Number limit；

4. Support 32-65536 Grayscale 16Bit, Support 262144 Grayscale, Restore image Details;

5. Independent Brightness Control of 3 Primary Colors, Easy to Adjust White Balance;

6. Support R,RB,RGB,RGBW,RGBWY, and Multi-Color Mixing Control;

7. Accurate Gamma Correction Algorithm, in Line With Human Visual Sense;

8. Support 120Hz Frame Rate to Ensure High-definition Display and 3D Requirements;

9. Using Ethernet Interface and UDP Protocol, The Distance is 100 Meters;

10. The LCD display module displays the controller parameters and status in time；

11. Support the device ID number data flow sequence and fixed arrangement；

12. Two RJ45 Ports, Support Mixed Cascading; Automatic Software Display Status;

13. A variety of chip control is integrated, and we change the control chip type, clock

frequency, duty cycle, gray scale level and other parameters through software setting；

14. 8-Port Output, Unlimited Number of Single-Port Load Points, Self-test;

15. Support dual backup, a controller is broken or a disconnected display is not affected；

16. Support Device Port Anti-interference and Leakage Design;

17. Support Overcurrent and Overvoltage Protection, Can run for a Long Time;

18. Equipment Network Port, Port OutPut, Surge Protection: 1.5KV;

19. Support Severe Working Environment -40℃-80℃, Normal Operation Without Failure.

Beijing Mingrui Lighting Technology Co., LTD

Address: Room 1105,Ruidu International Center, No.78, Jiukeshu West Road, Tongzhou District, Beijing

Postal code: 101100

Tel: 010-80816559 fax: 010-80816559-810 Website: www.bj-mrkj.com 3/10

20. Network Adaptive or Mandatory 100M Can be Set to Support More Loading;

II. Design Concept

1. 1000Mbps/ 100Mbps Optional，Adapt to Different Project Schemes；

2. Two-way Redundancy of The System Signal, Doubled Stability；

3. 4 Color Algorithm: Energy Saving and Environmental Protection, Pure Color;

4. Integrated Control,Online Priority, Automatic Switching Offline Effect Without Signal;

5. Self-developed Playback and Wiring Software,More Adaptable;

6. Use Complex Applications Such as Various Lighting Screens;

7. Use The Switch Parallel Scheme and Improve The Stability of The System;

8. Add Fiber Optic Modules, The System Can Transmit Fiber Optic Signals;

9. Add a Wireless Bridge for Wireless Signal Transmission;

10. With Internet Control Software, Support Internet Remote Control;

11. The System Supports Automatic, Timed and Holiday Preset Playing；

12. Support Mainstream 32Bit and 64Bit Systems：Win 7, Win 8 Win 10and so on；

III、Extensibility

1. Can Play Video and Picture File Content in Various Formats;

2. All Current Windows Systems and Multiple Languages Can be Installed;

3. Leave The Interface for Compatibility With International Common Protocols

4. Expandable and Compatible With Third-Party Software and Devices；

5. LED Driver Chips That Support all The Mainstream Serial Data interfaces on The

Market，Such as MBI6020、MBI6021、MBI6024、MBI6023、MBI6120、MBI6027、MBI6034、

MBI6033、MBI6030、LPD6803、LPD8806、LPD1886、LPD1882、TM1803、TM1804、

Beijing Mingrui Lighting Technology Co., LTD

Address: Room 1105,Ruidu International Center, No.78, Jiukeshu West Road, Tongzhou District, Beijing

Postal code: 101100

Tel: 010-80816559 fax: 010-80816559-810 Website: www.bj-mrkj.com 4/10

TM1829、TM1812、TM1914、TM1925、TM1926、TM1905、TM1905、TLS3001、TLS3008、

TLSGY01、MY9221、MY9231、MY9291、MY9234、WS2801、WS2811、WS2812B、

WS2818A、WS2816、CX808、P9813、P9823、P9883、AP102、AP104、GS8206、GS8208、

SM16716、BS0815、BS0901、BS0902、UCS1903、UCS1904、UCS1909、UCS1912、

UCS2903、UCS2904、UCS2912、UCS8903、UCS8904、UCS9812、UCS3903、UCS5603、

UCS2603、UCS8603、TI5971、TI5973、TI59731、GW6201、GW6205、GW6230、GW6236、

GW6212、GW6209、GW6206、GW6209、GW6212、GW6230A、GW6211、GW6803、

GW6606、SM16711、SM16716、SM16703P、SM16704P、SM16736、SM16803P、

SM16804P、SM16813P、SM16814P、SM16823E、SM16824E、SM16825E、SM15155E、

ICND2110、HX5011、ZQ1111、 LX1603、LX1203、HBS1916、HBS1910、HBS1510、

HB200B、KW1203A、CX808、DM412、DM413、DM621、MC2002、MC2.0、PM1.0、

MT1809、MT1815S、MT16703 etc。

Specifications and Parameters

I. Controller Appearance

MR-228A Front view：

① ② ③④ ⑤⑥

Beijing Mingrui Lighting Technology Co., LTD

Address: Room 1105,Ruidu International Center, No.78, Jiukeshu West Road, Tongzhou District, Beijing

Postal code: 101100

Tel: 010-80816559 fax: 010-80816559-810 Website: www.bj-mrkj.com 5/10

MR-228A Rear view ：

⑦ ⑧

① Power Switch ② LCD Display ③ Power Lights ④ Signal Lights

⑤⑥ Self-adapting Network Interface ⑦ DMX OutPut Port ⑧ Power Interface

II. Output port definition

MR-228A controller uses 8 5pin terminal interfaces to output signals。

5Pin terminals are sorted from left to right ,as below：

① ② ③ ④ ⑤

Note: MR-228A Supports TTL Signal and Differential Output.

III. Controller Three View Size Chart

MR-228A Front view

①

②

③

④

⑤

TTL Signal

GND

DATA

CLK

GND

DATA

CLK

Differential Signal

GND

DATA+

DATA-

GND

Beijing Mingrui Lighting Technology Co., LTD

Address: Room 1105,Ruidu International Center, No.78, Jiukeshu West Road, Tongzhou District, Beijing

Postal code: 101100

Tel: 010-80816559 fax: 010-80816559-810 Website: www.bj-mrkj.com 6/10

MR-228A Vertical view

MR-228A Rear view

Remark：Above Three Views The Size Unit is mm.

IV. Basic Parameter Table

Product Name

Standard TTL sub-controller

Product Model

MR-228A

Rated Voltage

AC 100V～240V±15%Vac50/60Hz

Rated Power

≤15W

Protocol

RJ45X2CH，Standard UDP/TCP protocol

Beijing Mingrui Lighting Technology Co., LTD

Address: Room 1105,Ruidu International Center, No.78, Jiukeshu West Road, Tongzhou District, Beijing

Postal code: 101100

Tel: 010-80816559 fax: 010-80816559-810 Website: www.bj-mrkj.com 7/10

Network Rate

100MB/1000MB self-adaption

Output Port

8-Port output (standard TTL output)

Relative Humidity

≤95%（Not condensation）

Temperature

-40℃～80℃；

Length

283mm

Width

134mm

Height

45mm

Hole Spacing

268mm；68 mm

Protection Class

IP20

Installation

Method

Installation method of fixed hole position（as above）

Weight

1.48kg

Shell Material

Iron quality (powder spraying process)

Accessories

AC power ×1/ warranty cardx1/Bubble cotton paper box x1

Install and Use

I、Online mode (Connected With The Computer )

MR-228A Controllerd Connect With The Computer Ethernet Port,as Shown Below：

Master Computer MR-228A-1 MR-228A-2 MR-228A-3 MR-228A-N

Beijing Mingrui Lighting Technology Co., LTD

Address: Room 1105,Ruidu International Center, No.78, Jiukeshu West Road, Tongzhou District, Beijing

Postal code: 101100

Tel: 010-80816559 fax: 010-80816559-810 Website: www.bj-mrkj.com 8/10

II、Offline Mode

MR-228A Connect With the Offline Master Controller，as Shown Below：

Master System MR-228A-1 MR-228A-2 MR-228A-3 MR-228A-N

III、Integrated synchronous and Asynchronous Mode

Connect With the Computer and The Main Control (Online Priority. No Signal Switch

Offline), as Shown in The Following Figure:

IV、Engineering Case Description and Sketch Map

For Example in DMX512 Point Light Source Composed of 96 Points × 18 Dots Matrix

Screen ， Use MR-228DW Controller ， The Wiring is Arranged in The Vertical S Type ，

Controller for Each OutPut Port to Control 3 lines Point Light Source, Totally Need of 32

DMX512 interfaces. The Following Diagram for Example：

MR-228DW

24 Port Switch

Master Computer

Beijing Mingrui Lighting Technology Co., LTD

Address: Room 1105,Ruidu International Center, No.78, Jiukeshu West Road, Tongzhou District, Beijing

Postal code: 101100

Tel: 010-80816559 fax: 010-80816559-810 Website: www.bj-mrkj.com 9/10

Master Computer Master System MR-228DW-1 MR-228DW-2 MR-228DW-N

Attention

I、Cat.5e Twisted Pair Application Notes

568B：orange-white/orange/green-white/ blue/blue-white/green/brown-white/brown

568A：green-white/green/orange-white/blue/blue-white/orange/brown-white/brown

Equipment and Equipment Cable, [Cross]: One end is 568B, and One end is 568A.

Device and Switch Cable, [Crossover]: One end is 568B, and One end is 568A.

Equipment and Computer Cable, [Straight]: One end is 568B, and One end is 568A.

Note: Follow The Requirements, Do Not Define The Network Cable Sequence by Yourself.

II、Wire and connecting method from lights to controller

1. If the distance between controller output port to the lamp is too far , recommended to

use super-five types of shielding network cable connection, the best method is : [Single line

chip]

Orange wire in the network cable : connect to DATA( data wire )

Note: All remaining unused wires must be connected to GND (ground)

[Double-line chip]

Beijing Mingrui Lighting Technology Co., LTD

Address: Room 1105,Ruidu International Center, No.78, Jiukeshu West Road, Tongzhou District, Beijing

Postal code: 101100

Tel: 010-80816559 fax: 010-80816559-810 Website: www.bj-mrkj.com 10 /10

Orange wire in the network cable : connect to DATA( data line )

Green wire in the network cable : connect to CLK (clock line)

Note: All remaining unused wires must be connected to GND (ground)

[Differential output]

Orange wire in the network cable : connect to DATA+ （Data line positive）

Orange-white wire in the network cable : connect to DATA- (Negative data line)

Note: All remaining unused wires must be connected to GND (ground)

2. wires wrapped together to connect the signals at the same time , such as orange and

orange-white connect to the data at the same time.

III、Controller Connect to Ground Application Notes

MR-228DW Controller Using Metal case，Rated Supply Voltage is AC100V-240V，Therefore,

it is Necessary to Ensure The Effective Grounding of The Controller Equipment and The

Effective Grounding of The Metal Outer Box。

And the OutPut Port of The Controller is Exposed to The Metal Contact Surface ，

Therefore, According to The Requirements of Safety Regulations，to Ensure Safe Use of The

Operator，Signal OutPut Port GND Signal Must be Effectively Grounded.

Olympia MR-228A User manual

Other documents