Tower Strobe
Strobe / Illumination Light Wiring Instructions
The following instructions are for wiring the beacon /strobe light on top of TW-Series towers, as well
as wiring the panel light located above the station mounting hole.
These instructions apply to models: TW-LCB, TW-LCK, TW-LCR, TW-LCW, and TW-LCY.
Locate the beacon/strobe wires and connect to a 24V DC power supply.
• Red to +24V DC
• Black to - (Ground)
• Connect the white trigger wire to one side of a Normally Open (NO) relay on the emergency sub
station. Connect the other side of the Normally Open (NO) relay to the positive of the 24V DC
power supply.
Locate the panel light wires and connect to a 24V DC power supply.
• Red to +24V DC
• Black to - (Ground)
+
-
24VDC
Panel Light
Strobe
Refer to the sub station installation manual for its
complete wiring and dip switch setting options.
Pg. 1
Relay board on back
of IX-RA sub stations
Pg. 2
Tower Strobe Instr.
0118
Aiphone Corporation
www.aiphone.com
800-692-0200
SPECIFICATIONS:
Beacon / Strobe:
Voltage: 24V DC
Current: 300 mA
144 mA @ 24VDC in steady state mode
272mA@24VDCinashingmode
Light source: LED
Luminous output: 247 lm
Wiring: Black: Ground
Red: +24V DC
White: Trigger (+24V DC)
Wiring Distance: 18awg, 980’
Operating temp: -40°F to 149°F
Panel light:
Voltage: 24V DC
Current: 24 mA
Light source: LED
Luminous output: 100 lm
Wiring: Black: Ground
Red: +24V DC
Wiring Distance: 18awg, 980’
Operating temp: -40°F to 149°F
6-½"
7-¼"
-
1
-
2
Aiphone TW-LCB Wiring Instructions
- Type
- Wiring Instructions
- This manual is also suitable for
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
Other documents
-
Mircom LT-2077 QX-MINI Operating instructions
-
-
SECO-LARM EAP-3D5Q Owner's manual
-
SECO-LARM EAP-5D5Q User manual
-
Bacharach MGS-408 User manual
-
-
-
-
-