Brodit 834771 Datasheet

Category
Holders
Type
Datasheet
27 January, 2015, www.brodit.com, © 2015 Brodit AB
Product 834771
834771 ProClip
Console mount, ONLY for models with a power outlet in the center of the (Hi / Low) buttons on the console. NOT
for models with a speaker on the right side of the console.
The ProClip is a mounting bracket for the vehicle’s dashboard. Onto the ProClip you can install e.g. a holder for
your mobile phone or PDA or a handsfree set etc. Safe and convenient -always within easy reach. The ProClip is
car specific and easy to install. The installation is quick, no special tools or dismantle of the dashboard is required
and it will not damage the interior of the vehicle. Made in black ABS plastic. Comes with detailed instructions.
EAN: 7320288347714
Item no 834771 fits:
Honda CR-V 12-15 (For Europe)
1(2)
1. 2.
INSTALLATION INSTRUCTIONS
4.3.
Please read all of the instructions and look at the pictures before attaching the ProClip.
1. Use the enclosed alcohol pad to clean the area where the ProClip is to be installed. Peel off the cover of
adhesive tape on the ProClip. Place the left side of the ProClip over the console edge.
2. Press firmly on the right side of the ProClip so it flexes down towards the floor. Press until the angled edge on
the lower part for the ProClip hooks around the console sidewall edge. Use your finger to press the mount
towards the console sidewall to make sure the angled edge is hooked all the way around the console edge
3 and 4. The ProClip is in place.
2(2)
  • Page 1 1
  • Page 2 2

Brodit 834771 Datasheet

Category
Holders
Type
Datasheet

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI