Digitus DS-31101-1 Owner's manual

Digitus
Brand
Digitus
Model
DS-31101-1
Category
Interface cards/adapters
Type
Owner's manual

Digitus DS-31101-1 is a high-speed ExpressCard/34 interface with a single eSATA port, enabling fast data transfer rates of up to 3.0Gbps, ideal for connecting external Serial ATA hard drives or SSDs. It supports hot-plugging, allowing you to easily connect and disconnect drives without restarting your system. Compatible with Windows 2000, XP, 2003, Vista, and 7 (32-bit and 64-bit), this ExpressCard is an excellent solution for expanding your computer's storage capabilities.

Digitus DS-31101-1 is a high-speed ExpressCard/34 interface with a single eSATA port, enabling fast data transfer rates of up to 3.0Gbps, ideal for connecting external Serial ATA hard drives or SSDs. It supports hot-plugging, allowing you to easily connect and disconnect drives without restarting your system. Compatible with Windows 2000, XP, 2003, Vista, and 7 (32-bit and 64-bit), this ExpressCard is an excellent solution for expanding your computer's storage capabilities.

ESATA II
EXPRESS CARD
User Manual
DS-31101-1
All brand names and trademarks are properties
of their respective owners.
2
Features and Benefits
Fully compliant with ExpressCard Specification 1.0
ExpressCard/34 Form Factor Module
Serial ATA generation 2 transfer rate of 3.0Gbps
One eSATA (external Serial ATA) port
Supports hot plug for external Serial ATA port
Support SATA II NCQ (Native Command Queuing)
to maximize system performance
Supports Windows
®
2000, XP/2003/Vista/7
(32-bit and 64-bit)
Bus Interface
ExpressCard/34
Connector
1 x eSATA
System Requirements
Windows
®
2000, XP/2003/Vista/7 (32-bit and 64-bit)
ExpressCard-enabled system with an available
ExpressCard slot
Package Contents
1 x eSATA II 300 1-Port ExpressCard
1 x Driver CD
1 x User Manual
Note: Contents may vary depending on country/market.
3
Hardware Installation
General instructions for installing the card are provided below.
Since the design of system may vary, refer to your system’s
reference manual for further information, if needed.
Insert the Card into the ExpressCard slot of your system.
Make sure it is inserted all the way in for a solid connection.
Driver Installation
1. Please insert the CD driver bound with eSATA II 300 1-Port
ExpressCard into your CD-ROM Drive.
2. At the Windows desktop, click Start, Run.
3. Type D:\ DS-31101-1\Setup.exe, click OK.
(Change D: to match your CD-ROM drive letter)
4. Follow the on-screen instructions to complete the installation
To Verify Driver Installation
1. Right click My Computer and click Manage.
2. Select Device Manager.
3. Look for the following:
Windows® 2000/XP/2003: Double click SCSI and RAID
Controller:
- Silicon Image SiI 3531 SATA Controller should be
displayed Windows
®
Vista/7:
Double click Storage controllers:
- Silicon Image SiI 3531 SATA Controller should
be displayed
4
Hot-Plugging Hard Disk Drives
To remove a drive from a powered up system,
do the following:
1. Right click My Computer and click Manage.
2. Select Device Manager.
3. Click Disk Drives, right click the target disk and
select Disable/Enable.
4. You can now remove the target disk.
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

Digitus DS-31101-1 Owner's manual

Digitus
Brand
Digitus
Model
DS-31101-1
Category
Interface cards/adapters
Type
Owner's manual

Digitus DS-31101-1 is a high-speed ExpressCard/34 interface with a single eSATA port, enabling fast data transfer rates of up to 3.0Gbps, ideal for connecting external Serial ATA hard drives or SSDs. It supports hot-plugging, allowing you to easily connect and disconnect drives without restarting your system. Compatible with Windows 2000, XP, 2003, Vista, and 7 (32-bit and 64-bit), this ExpressCard is an excellent solution for expanding your computer's storage capabilities.

Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents