Toolots 8600 User manual

8600 Electric Creasing Machine

Operation Manual

Component instructions

1Cover 2Knife frame 3Head screw

4Pressure adjusting screw 5Delivery board

6White bottom wheel 7Lower creasing wheel

8Right paper positioning device 9Adjusting screw

10 Left paper positioning device 11 Power line

12 Power switch 13 Perforating wheel

14 Upper creasing wheel 15 Sheet transfer wheel

Operation instruction

1. Take out the machine, put on the flat table.

2. Plug in, turn on the power switch, check the machine if it can run at

constant speed.

3. Adjust the left and right positioning devices according to the paper

size, the scale only for reference, you can fine adjust for the specific

size.

4. Adjust the creasing position and creasing number according to your

need, make the convex part of upper creasing wheel aim at the

concave part of the lower wheel on the creasing position.

5. Put in suitable paper, adjust the pressure of creasing wheels and sheet

transfer wheels. Turn the screw clockwise to add pressure, turn the

screw anticlockwise to lower pressure. Different paper with different

pressure.

6. Continue feeding paper manually, the creasing operation finished.

7. If you want to do perforate/slit, adjust the perforating/slitting wheel

and the lower white bottom wheel to the suitable position, adjust the

pressure to do perforate/slit. (The adjusting methods of pressure are

the same as the creasing wheel.)

Parameter:

Model

8600 Electric Creasing Machine

Creasing Wheel

Sheet Transfer Wheel

Perforating Wheel

Slitting Wheel

Power Supply

110V/60HZ

Packing Size

23.23"×14.57"×9.45" (590×370×240mm)

Machine Weight

26.5lb(12KG)