Component instructions
1Cover 2Knife frame 3Head screw
4Pressure adjusting screw 5Delivery board
6White bottom wheel 7Lower creasing wheel
8Right paper positioning device 9Adjusting screw
10 Left paper positioning device 11 Power line
12 Power switch 13 Perforating wheel
14 Upper creasing wheel 15 Sheet transfer wheel
Operation instruction
1. Take out the machine, put on the flat table.
2. Plug in, turn on the power switch, check the machine if it can run at
constant speed.
3. Adjust the left and right positioning devices according to the paper
size, the scale only for reference, you can fine adjust for the specific
size.
4. Adjust the creasing position and creasing number according to your
need, make the convex part of upper creasing wheel aim at the
concave part of the lower wheel on the creasing position.
