2. sonnax
  3. T9-28-1350FD
T9-28-1350FD

sonnax T9-28-1350FD Operating instructions

  • Hello! I am an AI chatbot trained to assist you with the sonnax T9-28-1350FD Operating instructions. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
Pinion Yoke
Part No.
T9-28-1350FD
• Yoke
• Spacer
NOTE: Fits all 9" Ford 28-spline differentials.
Uses 1350 U-joint. For 1330 U-joint, use
T9-28-1330FD.
Carrier Bearing Identification & Spacer Use
NOTE:
The included Sonnax spacer is used only in standard (small) bearing carriers.
If you have a big bearing OE, or a Daytona carrier, do not use Sonnax spacer (Figures 1–3).
NOTE:
When using Sonnax spacer, always install behind the pinion nut (like a washer) (Figure 2).
This spacer is NOT intended to be installed between the yoke and bearing.
Yoke
Spacer
Figure 1
Bearing Width* Pinion Bearing O.D. Use Sonnax Spacer
Standard Carrier 2.2" 2.675" Yes
Big Bearing Carrier/Daytona 2.5" 3" No
*Bearing width is the width between outer bearing faces when installed in the carrier.
Figure 2
Spacer
*Bearing
"Width"
Pinion Nut
Bearing Carrier
Rear Bearing
Front Bearing
Pinion
Bearing O.D.
Pinion
Yoke
Pinion Gear &
Integral Shaft
Standard Bearing Carrier Figure 3
Bearing Carrier
Rear Bearing
Front Bearing
Pinion
Bearing O.D.
No
Sonnax Spacer
*Bearing
"Width"
Big Bearing Carrier
Pinion
Yoke
Pinion Gear &
Integral Shaft
Pinion Nut
©2021 Sonnax Transmission Company, Inc. • A Marmon / Berkshire Hathaway Company T9-28-1350FD-IN 11-09-21
800-843-2600 • 802-463-9722 • F: 802-463-4059 • www.sonnax.com
Instructions
HIGH PERFORMANCE DRIVELINE PARTS
PERFORMANCE
/