sonnax T9-28-1350FD Operating instructions

Brand: sonnax

Model: T9-28-1350FD

Type: Operating instructions

Pinion Yoke

Part No.

T9-28-1350FD

• Yoke

• Spacer

NOTE: Fits all 9" Ford 28-spline differentials.

Uses 1350 U-joint. For 1330 U-joint, use

T9-28-1330FD.

Carrier Bearing Identification & Spacer Use

NOTE:

The included Sonnax spacer is used only in standard (small) bearing carriers.

If you have a big bearing OE, or a Daytona carrier, do not use Sonnax spacer (Figures 1–3).

NOTE:

When using Sonnax spacer, always install behind the pinion nut (like a washer) (Figure 2).

This spacer is NOT intended to be installed between the yoke and bearing.

Yoke

Spacer

Figure 1

Bearing Width* Pinion Bearing O.D. Use Sonnax Spacer

Standard Carrier 2.2" 2.675" Yes

Big Bearing Carrier/Daytona 2.5" 3" No

*Bearing width is the width between outer bearing faces when installed in the carrier.

Figure 2

Spacer

*Bearing

"Width"

Pinion Nut

Bearing Carrier

Rear Bearing

Front Bearing

Pinion

Bearing O.D.

Pinion

Yoke

Pinion Gear &

Integral Shaft

Standard Bearing Carrier Figure 3

Bearing Carrier

Rear Bearing

Front Bearing

Pinion

Bearing O.D.

Sonnax Spacer

*Bearing

"Width"

Big Bearing Carrier

Pinion

Yoke

Pinion Gear &

Integral Shaft

Pinion Nut

800-843-2600 • 802-463-9722 • F: 802-463-4059 • www.sonnax.com

Instructions

HIGH PERFORMANCE DRIVELINE PARTS

PERFORMANCE

sonnax T9-28-1350FD Operating instructions

sonnax T9-28-1350FD Operating instructions

sonnax T9-28-1350FD Operating instructions

Related papers

Other documents