2. Ford
  3. 413-01
413-01

Ford 413-01 Installation guide

  • Hello! I have reviewed the user manual for the Instrument Panel Cluster (IPC) of the Ford F-150 2021. This document provides detailed instructions on how to remove and install the IPC, use diagnostic tools, and program module. I'm ready to answer your questions about this process.
  • What tool is needed to remove the trim panels?
    What is PMI process?
    What should be done if the odometer value cannot be obtained from the IPC?
413-01 Instrumentation, Message Center and Warning Chimes 2021 F-150
Removal and Installation Procedure revision date: 10/2/2020
Instrument Panel Cluster (IPC)
Special Tool(s) / General Equipment
Interior Trim Remover
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. NOTE: If installing a new module, it is necessary to upload the module configuration information to the scan tool prior to
removing the module. This information must be downloaded into the new module after installation.
Using a diagnostic scan tool, begin the PMI process for the IPC following the on-screen instructions. Record the odometer
value from the original IPC . If the odometer value cannot be obtained from the IPC (display failure), perform the diagnostic
routine. If the value cannot be obtained after the diagnostic routine, the customer should supply the approximate odometer
value.
2. NOTE: 12 inch screen is shown, 10 inch screen is similar.
Release the clips and remove the upper centerstack bezel.
Remove the General Equipment: Interior Trim Remover
3. NOTE: 12 inch screen is shown, 10 inch screen is similar.
Release the clips and remove the RH instrument center trim panel.
Remove the General Equipment: Interior Trim Remover
On vehicles equipped with push button start disconnect the electrical connector.
4. Release the clips and remove the LH instrument center trim panel.
Remove the General Equipment: Interior Trim Remover
5. Release the clips and remove the lower steering column closeout panel.
Remove the General Equipment: Interior Trim Remover
6. Fully extend and lower the steering column.
7. Release the tabs and disconnect the gap hider from the upper steering column shroud.
Remove the General Equipment: Interior Trim Remover
8. Remove the screws.
Torque: 22 lb.in (2.5 Nm)
9. Release the clips and remove the instrument cluster panel bezel.
10. Remove the screws.
Torque: 22 lb.in (2.5 Nm)
11. Disconnect the electrical connectors and remove the IPC .
Installation
1. To install, reverse the removal procedure.
2. Using a diagnostic scan tool, complete the PMI process for the IPC following the on-screen instructions.
© Copyright 2022, Ford Motor Company.
/