ESL VISION LED Round High Bay Installation guide

Brand: ESL VISION

Model: LED Round High Bay

Type: Installation guide

ESL VISION LED Round High Bay features a dimming wire for 0–10V IEC compliant control, allowing for precise light adjustment. Its sturdy construction and long-lasting LED bulbs make it ideal for high-ceiling applications such as warehouses, factories, and gymnasiums, providing years of energy-efficient illumination. Installation requires professional handling by a licensed electrician, ensuring proper wiring and compliance with local electrical codes.

LED ROUND HIGH BAY SERIES

RHB Installation Guide Page 1 of 1

1. To reduce the risk of death, personal injury or property damage from ﬁre,

electric shock, falling parts, cuts/abrasions, and other hazards read all

warnings and instructions included with and on the ﬁxture box and all

ﬁxture labels.

2. Before installing, servicing, or performing routine maintenance upon this

equipment, follow these general precautions.

3. Commercial installation, service and maintenance of luminaire should be

performed by a qualiﬁed licensed electrician.

4. If you are unsure about the installation or maintenance of the luminaire,

consult a qualiﬁed licensed electrician and check your local electrical code.

5. To prevent wire damage or abrasion, do not expose wiring to edges of

sheet metal or other sharp objects.

6. Do not make or alter any open holes in an enclosure of wiring or electrical

components during kit installation.

7. Turn o electrical power at fuse or circuit breaker box before wiring ﬁxture

to the power supply.

8. Turn o the power when you perform any maintenance.

9. Verify that supply voltage is correct by comparing it with the luminaire

label information

10. All wiring connections should be capped with UL approved wire connectors.

WARNING CAUTION

1. Avoid direct eye exposure to the light source

while it is on.

2. Account for small parts and destroy packing

material, as these may be hazardous to children.

3. Risk of burn. Disconnect power and allow ﬁxture

to cool before changing bulb or handing ﬁxture.

Installation Instructions

1First install the hook to the RHB fixture

using the provided screws to mount to

the hook to the fixture. 2

Install the provided safety wire. 3Attached the fixture hook to a pre-

installed ring in the ceiling. Install

the provided screw into the hook.

Yoke Installation Instructions

1Install the L-brackets to the fixture. 2

Mount the yoke to the L-brackets. 3Mount to surface.

General Wiring Guide

120–277 VAC

Black(Line)

White(Neutral)

Green(Ground)

Purple(Dim+)

Grey(Dim-)

Blue(-)

Red(+)

Dimming wire

to 0–10V IEC compliant control

Lead wire to LED load

LED Driver

ESL VISION LED Round High Bay Installation guide

ESL VISION LED Round High Bay Installation guide

ESL VISION LED Round High Bay Installation guide

Other documents