GB-1 GB-2
P R O D U C T O V E R V I E W
U N PA C K I N G
Remove all packaging from the unit. Retain the packaging. If you dispose of it
please do so according to local regulations.
The following items are included:
• The Main Unit
• The Water Hose (P.N.: 202725490014)
• The Water Tank (P.N.: 201126290155)
• The Instruction Manual (P.N.: 202000191009)
If items are missing or damaged, please contact Partmaster (UK only).
Tel: 0844 800 3456 for assistance.
The unit must stand upright for at least 2 hours prior to use.
When the hose is not being used, remove the hose from the drain outlet.
The hose level must be lower than the drain outlet, see diagrams below.
• If the unit has been switched off and needs to be switched on again
quickly, allow approximately three minutes for the correct operation to
resume.
• Always press the ON/OFF button to switch the unit off. The unit have
delay function to protect itself if user shut the unit o not properly in
previous operation.
GB-3
B E F O R E U S E
1. Place on a stable, at oor. If the oor surface is not even:
• Vibration and noise will occur.
• Water may leak from the water tank
2. Make sure the air inlet and air outlet openings are clear and free from blockage.
S TA R T O P E R AT I O N
1. Connect to the mains socket.
2. Press the ON/OFF button to switch the unit on.
3. Press the ON/OFF button to switch the unit o.
WAT E R TA N K F U L L
When the water tank is full, the WATER FULL
indicator will illuminate and the unit will
automatically stop operating. Switch o the unit
and remove the water tank. Empty the water and
then ret the water tank back to the unit. Wait for
approx. 3 min, then switch the unit on again and
continue operation.
CONTINUOUS DRAINING
Water can be automatically emptied into a oor
drain by attaching the unit with a water hose
(13.5mm).
• Remove the rubber plug from the back of the unit.
• Insert the water hose into the unit from the drain
outlet in the back of the unit as shown. Lead the
water hose to a suitable drainage facility.
C L E A N I N G & M A I N T E N A N C E
Maintenance of your air lter
The air lter located inside the air inlet of the unit collects dust contained in the air.
The build up of dust reduces the efficiency of the unit. To prevent the dust from
clogging up the unit always use it with the air lter in place.
Always clean the air lter every 2 weeks. If the
unit operates in a dusty atmosphere clean the air
lter more often.
• To remove the lter, pull down the plastic lip at
the bottom of the vents as shown.
• Clean the air lter with a vacuum cleaner. lf the
air lter is very dirty, you can wash it in warm
water (never use hot or soapy water). Make
sure that the air lter is dry and retted
correctly to the unit. Do not bend the lter and
ensure it is tted before operating the unit.
Cleaning the unit
• Clean the unit by using a damp sponge, and dry it with a clean, soft cloth.
• Never use alcohol or any product containing solvents.
• Do not immerse the unit in water.
H I N T S & T I P S
Air Intake
Water Tank
Water Level Window
Water Hose
Air Filter
(behind the air intake)
POWER WATER FULL
Front View
Control Panel
1
3
2
Control Panel
Mains Cable Band
Air Outlet
Handle
Drain Hose Outlet
Rubber Plug
Rear View
Mains Cable
Power Indicator : Illuminates when the unit is in operation.
Water Full Indicator: Illuminates when the water tank is full or not in place.
ON/OFF Button: Press to turn the unit on and o.
1
3
2
S U I TA B L E F O R U S E I N
• Bedrooms • Studies
• Cellars / Basements • Kitchens
• Storage rooms • Libraries
• Galleries • Computer rooms
Protects moisture sensitive items, such as :
• Musical instruments • Cameras
• Computers
Benets:
• Prevents clothes and leather products from moulding.
• Dehumidies ooring and carpets.
• Prevents ceiling and windows from condensation.
• To obtain best results, try to avoid opening and closing windows and doors.
Water
Hose
Rubber
Plug
Drain
Outlet
• Empty the water tank.
• Ret the water tank in correct position.
The WATER FULL indicator
illuminates.
Clean the air lter. Make sure that the air inlet
and the air outlet are not obstructed.
Dehumidifying function
does not work.
Ensure the unit is on a stable at surface.
Clean the air lter.
Excessive noise.
Clean the air lter.No air coming out from the
air outlet.
Problems Solutions
C10DHW11_IB_wait PN_111019.pdf 2 19/10/2011 11:42 AM