DOMUS NEO-10-SM-TILT Surface Mount Tiltable LED Dimmable Downlight User manual

I have reviewed the provided installation manual for the DOMUS NEO-10-SM-TILT LED Light. This manual includes detailed instructions on how to install the light fixture, including taking out the fixtures, loosening screws, hammering anchors, fixing the frame, the terminal block and screwing back the lamp. I'm ready to answer any questions you may have about installing or using your new device.
What is the voltage requirement for this LED light?

What is the IP rating of this light?

Is this light dimmable?

What is the lifespan of this LED light?

29-31 Richland St. Kingsgrove. Sydney NSW 2208 Australia

Phone: 02 9554 9600 | Fax: 02 9554 9433

[email protected] | www.domuslighting.com

Installation Manual

Speciﬁcations

Voltage: 240V Lumen (±5%): Warm White 3000K - 880lm

Neutral White 4000K - 960lm

White 5000K - 945lm

Dimmable: Ye s

Power: 10W Beam Angle: 60° Operating Temp: -20°C~45°C

IP Rating: IP20 CCT: 3000K - 4000K - 5000K (Switchable) Power Factor: 0.85

CRI: ≥80 Lifespan: 50,000hrs

Note: -The lamp must be installed by professional electrician

-Ensure the power supply is switched oﬀ before ﬁtting this product

-Do not touch the lamp when in use

-Keep away from hot steam and corrosive gas

Step 1: Take out the ﬁxtures and

ﬁng from the carton.

Step 2: Loosen the screws on

surface mounted frame.

Step 3: Hammer the anchors into the

ceiling according to the hole distance

Step 4: Fix the frame to the ceiling

with screws provided.

Step 5: Fix the “L””N”“G”into the

terminal block.

Step 6: Screw back the lamp to the frame

according to step 2, adjust

the lighng direcon.

10W

20W

80mm

56mm

NEO-10-SM-TILT March 18, 2022 10:11 AM

Variants Item No. Colour Temp

Blk Wht

21294 21298 NEO-10-SM-TILT TRIO

Thank you for purchasing your new LED NEO-10-SM-TILT, Please take the time to read and understand the instruction sheet below.

Failure to do so may void warranty.

/

Related papers

Other documents