Sunricher SR-2801E User manual

Brand: Sunricher

Model: SR-2801E

Type: User manual

RF Single Color Remote Controller 09.2801E.04105

All lights: Click to turn on

Note:Before the first use, please remove the protective film on the battery.

Function introduction

Important: Read All Instructions Prior to Installation

Output RF signal

Operation Frequency 868/915/434MHz

Operating temperature 0-40°C

Relative humidity 8% to 80%

Dimensions 136.3x38.9x10.7mm

Front side

Back side

• Control 4 channels of one receiver separately

• Single color controller

• Compatible with all universal series RF receivers

• 1 receiver can be paired by max 8 different remote controls.

• Waterproof grade: IP20

Product Data

• This device contains a button lithium battery that shall be stored and disposed properly.

• DO NOT expose the device to moisture.

Safety & Warnings

Power Supply 3V(1xCR2025 battery)

Channel 1:Click to turn on,

Press and hold down to increase

light intensity

Channel

Press and hold down to increase

light intensity

2:Click to turn on,

Channel 3

Press and hold down to increase

light intensity

:Click to turn on,

Channel 4

Press and hold down to increase

light intensity

:Click to turn on,

All : Click to turn offlights

Channel 1:Click to turn off,

Press and hold down to decrease

light intensity

Channel 2

Press and hold down to decrease

light intensity

:Click to turn off,

Channel 3

Press and hold down to decrease

light intensity

:Click to turn off,

Channel 4

Press and hold down to decrease

light intensity

:Click to turn off,

Step 3:Click or of all lights, LED lights connected with the RF receiver

flicker once means the receiver is paired with the remote successfully.

Step 2:

three times continuously to set it into pairing status

Click the “Learning Key” button on RF receiver or re-power on the receiver

Note: one receiver can be paired with max 8 remote controls.

Learning Key

RF LED Receiver

Step 1:Do wiring the RF receiver according to wiring diagram(please refer to the

instruction of RF receiver that you would like to pair with.

Pair with RF receiver

After pairing, click or hold or of ch1/ch2/ch3/ch4 to control each channel

of the receiver separately, If the receiver has less than four channels ,the receiver

will not react when operating the extra channels.

Sunricher SR-2801E User manual

Sunricher SR-2801E User manual

Sunricher SR-2801E User manual

Related papers

Other documents