2. OTC
  3. J-47399

OTC J-47399 Operating instructions

  • Hello! I've reviewed the user manual for the Kent-Moore J-47399 DPF Handler. This manual provides important information about maintenance, safety precautions, and parts. It also covers the safe use of the handler and what you should do before each use. I'm ready to answer your questions about this product.
  • What is the maximum capacity of the J-47399 DPF Handler?
    What type of hydraulic fluid should be used with this device?
    How often should the oil in the reservoir be replaced?
J-47399 HORIZONTAL DPF HANDLER
Replacement Parts
1. 527901 Caster Kit
2. 527903 Handle Kit
3. 527917 Handle Pivot Kit
Maintenance
IMPORTANT: Dirt is the greatest single cause of failure in hydraulic units. Keep the jack clean and well lubricated to
prevent foreign matter from entering the system. If the jack has been exposed to rain, snow, sand, or grit, it must
be cleaned before it is used.
1. Store the jack in a well-protected area where it will not be exposed to corrosive vapors, abrasive dust,
or any other harmful element.
2. Regularly lubricate the moving parts.
3. Replace the oil in the reservoir at least once per year. To check the oil level, place the jack on level ground and lower
the lift arm completely. Remove the filler plug. The oil level should be within 3/8” of the filler plug hole. If necessary, add
approved anti-wear hydraulic jack oil, and install the filler plug again. IMPORTANT: Use only approved hydraulic fluid
(Chevron AW Hydraulic Oil MV or equivalent). The use of alcohol or hydraulic brake fluid could damage seals and
result in jack failure.
4. Inspect the jack before each use. Take corrective action if any of the following problems are found:
a. Cracked or damaged housing
b. Excessive wear, bending, or other damage
c. Leaking hydraulic fluid
d. Scored or damaged piston rod
e. Malfunctioning swivel heads or adjusting screws
f. Loose hardware
g. Modified or altered equipment
1
2
3
Note: Reference jack part number 1521A
for additional replacement parts
SPX SERVICE SOLUTIONS • 655 EISENHOWER DR • OWATONNA, MN 55060-0995
PHONE 800-345-2233 • FAX 586-578-7375
Maximum Capacity: 300 lbs.
Safety Precautions
WARNING: To prevent presonal injury and/or property damage,
• Study,understand,andfollowallinstructionsbeforeoperatingthisdevice.Iftheoperatorcannotread
or understand these operating instructions and safety precautions, they must be read and discussed
in the operator’s native language.
• WeareyeprotectionthatmeetsANSIZ87.1andOSHAstandards.
• Useonlyonhard,levelsurfaces.
• Inspectthejackbeforeeachuse;donotusethejackifitisdamaged,altered,orinpoorcondition.
• NoalterationsshallbemadetothisproductunlessapprovedbyOTC.Ifamodificationisneeded,
 contactOTCTechnicalServices.
• Useofthisproductislimitedtotheremoval,installation,andtransportationintheloweredposition
of only automotive or truck transmissions.
• Donotexceedtheratedcapacityof1,000lbs.(500kg).
• Adequatelysupportthevehiclebeforestartingrepairs.
• Stayoutfromunderneaththeloadatalltimes.
• Securetheloadtothejack.
• Lowerthejackslowlyandcarefullywhilewatchingthepositionoftheload.
• SLOWLYANDCAREFULLYmovethejackaroundcorners.
• Useonlyapprovedhydraulicfluid(ChevronAWHydraulicOilMVorequivalent).Theuseofalcohol
or hydraulic brake fluid could damge seals and result in jack failure.
549610REVA
/